the card i have has the ZR36057 chip on it and i read it is supported.
this appears to be the reason it's not working (good guess, eh?)... why
do i get:
MJPEG[0]: Zoran ZR36057 (rev 1) irq: 9, memory: 0xffae7000.
MJPEG[0]: Changing PCI latency from 64 to 48.
MJPEG[0]: Initializing i2c bus...
MJPEG[0]: Card not supported

is this just not gonna work? here is my dmesg output (i tried most of the
related modules to get it working):

Linux version 2.4.22 ([EMAIL PROTECTED]) (gcc version 3.2) #1 Thu Sep 18
16:43:39
 UTC 2003
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000007c00000 (usable)
 BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved)
 BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved)
 BIOS-e820: 00000000fffe0000 - 0000000100000000 (reserved)
124MB LOWMEM available.
On node 0 totalpages: 31744
zone(0): 4096 pages.
zone(1): 27648 pages.
zone(2): 0 pages.
DMI not present.
Kernel command line: BOOT_IMAGE=2.4.22-test ro root=3a00
Initializing CPU#0
Detected 200.454 MHz processor.
Console: colour VGA+ 80x30
Calibrating delay loop... 399.76 BogoMIPS
Memory: 122056k/126976k available (1129k kernel code, 4532k reserved,
279k data,
 244k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode...
Ok.
Dentry cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
CPU:     After generic, caps: 0080a135 00000000 00000000 00000004
CPU:             Common caps: 0080a135 00000000 00000000 00000004
CPU: Cyrix M II 3x Core/Bus Clock stepping 08
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch ([EMAIL PROTECTED])
mtrr: detected mtrr type: Cyrix ARR
PCI: PCI BIOS revision 2.10 entry at 0xfdb91, last bus=0
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Disabling direct PCI/PCI transfers.
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
Starting kswapd
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ
SERIAL_PCI en
abled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
See Documentation/networking/vortex.txt
00:0b.0: 3Com PCI 3c905 Boomerang 100baseTx at 0xf700. Vers LK1.1.18-ac
PCI: Setting latency timer of device 00:0b.0 to 32
 00:60:08:2b:11:18, IRQ 10
  product code 4b4b rev 00.0 date 06-29-97
  Internal config register is 16302d8, transceivers 0xe040.
  8K word-wide RAM 3:5 Rx:Tx split, autoselect/MII interface.
  MII transceiver found at address 24, status 786d.
  Enabling bus-master transmits and whole-frame receives.
00:0b.0: scatter/gather enabled. h/w checksums disabled
eth0: Dropping NETIF_F_SG since no checksum feature.
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
SIS5513: IDE controller at PCI slot 00:01.1
SIS5513: chipset revision 208
SIS5513: not 100% native mode: will probe irqs later
SIS5513: SiS5597 ATA 33 controller
    ide0: BM-DMA at 0x4000-0x4007, BIOS settings: hda:pio, hdb:pio
    ide1: BM-DMA at 0x4008-0x400f, BIOS settings: hdc:pio, hdd:pio
hda: ST33221A, ATA DISK drive
blk: queue c02c5820, I/O limit 4095Mb (mask 0xffffffff)
hdc: Maxtor 82160D2, ATA DISK drive
hdd: MATSHITA CR-583, ATAPI CD/DVD-ROM drive
blk: queue c02c5c74, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: attached ide-disk driver.
hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_no_data_intr: error=0x04 { DriveStatusError }
hda: 6303024 sectors (3227 MB) w/128KiB Cache, CHS=781/128/63, UDMA(33)
hdc: attached ide-disk driver.
hdc: host protected area => 1
hdc: 4219592 sectors (2160 MB) w/256KiB Cache, CHS=4465/15/63, UDMA(33)
hdd: attached ide-cdrom driver.
hdd: ATAPI 8X CD-ROM drive, 128kB Cache, DMA
Uniform CD-ROM driver Revision: 3.12
Partition check:
 hda: hda1 hda2
 hdc: [PTBL] [523/128/63] hdc1 hdc2
LVM version 1.0.5+(22/07/2002)
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 1150k freed
VFS: Mounted root (ext2 filesystem).
reiserfs: found format "3.6" with standard journal
reiserfs: checking transaction log (device lvm(58,0)) ...
for (lvm(58,0))
lvm(58,0):Using r5 hash to sort names
VFS: Mounted root (reiserfs filesystem) readonly.
Trying to move old root to /initrd ... failed
Unmounting old root
Trying to free ramdisk memory ... okay
Freeing unused kernel memory: 244k freed
Adding Swap: 161272k swap-space (priority 1)
smbfs: Unrecognized mount option noexec
i2c: initialized
Linux video capture interface: v1.00
i2c-core.o: i2c core module
i2c-algo-bit.o: i2c bit algorithm module
bttv: driver version 0.7.107 loaded
bttv: using 4 buffers with 2080k (8320k total) for capture
bttv: Host bridge is Silicon Integrated Systems [SiS] 5597 [SiS5582]
bttv: BT848 and your chipset may not work together.
bttv: going to disable overlay.
i2c-core.o: i2c core module
i2c-core.o: driver i2c msp3400 driver registered.
i2c-core.o: driver i2c tda7432 driver registered.
i2c-core.o: driver i2c tda9875 driver registered.
i2c-core.o: driver i2c tda9887 driver registered.
i2c-core.o: driver i2c TV tuner driver registered.
tvaudio: TV audio decoder + audio/video mux driver
tvaudio: known chips:
tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6420,tda8425,pic16c54
(PV951),ta8874z
i2c-core.o: driver generic i2c audio driver registered.
Zoran ZR36060 + ZR36057/67 MJPEG board driver version 0.7
MJPEG[0]: Zoran ZR36057 (rev 1) irq: 9, memory: 0xffae7000.
MJPEG[0]: Changing PCI latency from 64 to 48.
MJPEG[0]: Initializing i2c bus...
MJPEG[0]: Card not supported
No known MJPEG cards found.
i2c-dev.o: i2c /dev entries driver module
i2c-core.o: driver i2c-dev dummy driver registered.
i2c-proc.o version 2.6.1 (20010825)
i2c-algo-bit.o: i2c bit algorithm module


thanx!

^ jesse kahtava | [EMAIL PROTECTED] ^
pleaze, no mayonaisse... http://www.fastmail.fm kiks


-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
_______________________________________________
Mjpeg-users mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/mjpeg-users

Reply via email to