I've gone through the steps outlined in release(8) to create a release set which then i used mkisofs and cdrecord from cdrtools (ports) to burn a CD image that I use to upgrade my other machines with. The last two times I had to do this, after an errata update, I notice that during the set install time base46.tgz stalls towards the end (this time at 77%):
base46.tgz 77% |***************** | 36648 KB - stalled - (above is hand copied obviously) The sets are being installed off of the same PC's CD drive. So I'm not sure what is this indicating? At first I thought maybe bad CD-Rs, but copying the .tgz sets to local disk and using this path during the upgrade also stalls at the same point (77% 36648 KB). I don't recall what I did to get past this last time. Any ideas? --patrick This is a GENERIC i386 4.6 system, following errata and using cvs up -rOPENBSD_4_6
