Hi,
I have a Dell PE2950 server with DRAC 5 running OpenBSD 4.5 AMD64. I
would like to remotely access the console using an SSH session to the
DRAC IP address. I am hoping someone can help me with this.
This is what I have so far.
On the Server's Setup, under Serial Communications I have the following:
Serial Communication: On with Console Redirection via COM2
External Serial Connector: Remote Access Device
Failsafe Baud Rate: 115200
Remote Terminal Type: VT100/Vt220
Redirection after Boot: Enabled
From my OpenBSD Desktop, I am able to do a r...@192.168.0.120 and get
the following:
Dell Remote Access Controller 5 (DRAC 5)
Firmware Version 1.40 (Build 08.08.22)
$
I can do a "connect com2" but can't get the console text appear within
the ssh session.
I tried "set tty com1" in /etc/boot.conf and that did not work. Is it
possible to get the console send its output to com2 and have that
accessed through DRAC's IP? Or is there some other way to access the
OpenBSD console through DRAC?
Thanks very much,
Vijay
vsan...@foretell.ca
