Paul de Weerd wrote:
On Thu, Sep 11, 2008 at 11:59:55AM +0200, Paul de Weerd wrote:
| On Thu, Sep 11, 2008 at 11:33:43AM +0200, Heinrich Rebehn wrote:
| > Paul,
| >
| > when you had success with rum(4), did you use wpa? I am having trouble
| > getting a Hercules HWGUSB2-54 under OpenBSD 4.4 to work with my FritzBox
| > 7220 using wpa(tkip). At start, the association succeeds, but after some 15
| > minutes it disassociates and than fails to reassociate until i either
| > reboot the AP or the OpenBSD box. The fritzbox reports authentication
| > errors. If this works for you, then i would suspect that the fritzbox is to
| > blame.
|
| No, I did not use rum(4) with wpa. I can try this sometime later this
| week, will let you know the results.
A bit later than anticipated, but I found a (one of my) rum(4) and
tried it with a FON WPA access point. So far, I've transferred 5+GB of
data through this NIC without any issues whatsoever, all using WPA.
[EMAIL PROTECTED] $ netstat -nb -I rum0
Name Mtu Network Address Ibytes Obytes
rum0 150d <Link> 00:80:5a:37:c2:f4 5648770470 170570816
I've seen no association errors or anything.
Strange. Is your AP also Atheros-based? So far, i had troubles with two
APs, both Atheros-based.
There's only this :
ehci_idone: ex=0xffff800000221600 is done!
>
> Which I got a couple of times (mostly during ifconfig).
Yes, i have seen that too, looks more like an informational message.
Anyway, thank you for your effort! :-)
I will try running the WLAN w/o WPA and encrypt traffic with IPSec or
OpenVPN.
Cheers,
Heinrich
