I just installed the July 25th snapshot on my brand-new ALIX 6B2
board. After learning how to PXEBOOT (thanks to the manpages and
FAQ), I was able to install. I did the default install (comp, base,
bsd, games, etc, misc, man, and bsd.rd), plus xbase and xetc (this
board will be my low-visitor webpage, tikiwiki needs gd, which needs
things in xbase).
After I rebooted, the following came up when the server attempted to
create the SSH keys (RSA, RSA1, DSA):
----------------------------------------------------------------------------
ssh-keygen: generating new DSA host key... /usr/bin/ssh-keygen: can't
load library 'libcrypto.so.14.0'
failed.
ssh-keygen: generating new RSA host key... /usr/bin/ssh-keygen: can't
load library 'libcrypto.so.14.0'
failed.
ssh-keygen: generating new RSA1 host key... /usr/bin/ssh-keygen: can't
load library 'libcrypto.so.14.0'
failed.
openssl: generating new isakmpd RSA key... failed.
starting network daemons: sendmail inetd sshd/usr/sbin/sshd: can't
load library 'libcrypto.so.14.0'
---------------------------------------------------------------------------
Should wait for the next snapshot and try again, or is there another issue?
Attempting to ssh out from the board says that it can't load libcrypto either.
Here is my complete dmesg:
PC Engines ALIX.2 v0.99
640 KB Base Memory
261120 KB Extended Memory
01F0 Master 044A TRANSCEND
Phys C/H/S 15538/16/63 Log C/H/S 974/255/63 LBA
Using drive 0, partition 3;
Loading;...
probing: pc0 com0 pci mem[640K 255M a20=on]
disk: hd0
>> OpenBSD/i386 BOOT 3.02
switching console to com0
>> OpenBSD/i386 BOOT 3.02
boot>
booting hd0a:/bsd: 6051200+1025140 [52+315264+297769]=0x755648
entry point at 0x200120
[ using 613460 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2008 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 4.4-beta (GENERIC) #989: Fri Jul 25 00:07:57 MDT 2008
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD"
586-class) 499 MHz
cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX
real mem = 268009472 (255MB)
avail mem = 250925056 (239MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 12/10/07, BIOS32 rev. 0 @ 0xfceb2
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xe0000/0xa800
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33
glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10,
address 00:0d:b9:15:81:38
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11,
address 00:0d:b9:15:81:39
ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 0,
32-bit 3579545Hz timer, watchdog, gpio
gpio0 at glxpcib0: 32 pins
pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <TRANSCEND>
wd0: 1-sector PIO, LBA, 7647MB, 15662304 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 ignored (disabled)
ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 15,
version 1.0, legacy support
ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 15
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1
isa0 at glxpcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: console
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
usb1 at ohci0: USB revision 1.0
uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1
biomask f3ef netmask ffef ttymask ffff
mtrr: K6-family MTRR support (2 registers)
nvram: invalid checksum
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
clock: unknown CMOS layout
Automatic boot in progress: starting file system checks.
/dev/rwd0a: file system is clean; not checking
/dev/rwd0g: file system is clean; not checking
/dev/rwd0e: file system is clean; not checking
/dev/rwd0d: file system is clean; not checking
/dev/rwd0h: file system is clean; not checking
/dev/rwd0f: file system is clean; not checking
setting tty flags
starting network
starting system logger
starting initial daemons: ntpd.
savecore: no core dump
checking quotas: done.
building ps databases: kvm dev.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files.
ssh-keygen: generating new DSA host key... /usr/bin/ssh-keygen: can't
load library 'libcrypto.so.14.0'
failed.
ssh-keygen: generating new RSA host key... /usr/bin/ssh-keygen: can't
load library 'libcrypto.so.14.0'
failed.
ssh-keygen: generating new RSA1 host key... /usr/bin/ssh-keygen: can't
load library 'libcrypto.so.14.0'
failed.
openssl: generating new isakmpd RSA key... failed.
starting network daemons: sendmail inetd sshd/usr/sbin/sshd: can't
load library 'libcrypto.so.14.0'
.
starting local daemons:.
standard daemons: cron.
Fri Jul 25 07:02:48 UTC 2008
OpenBSD/i386 (server.my.domain) (tty00)
login: root
