Hi,
I have installed OpenBSD 4.2 GENERIC#1517 macppc
on my Powerbook G4 (dmesg below) to use it as a server.
Is there a way to power down the screen to save power?
Floor Terra
[ using 375776 bytes of bsd ELF symbol table ]
console out [NVDA,Display-A]console in [keyboard] ADB found
using parent NVDA,Parent:: memaddr a0000000 size 10000000, : consaddr
a0008000, : ioaddr 91000000, size 1000000: memtag 8000, iotag 8000:
width 1024 linebytes 1024 height 768 depth 8
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2007 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 4.2 (GENERIC) #1517: Tue Aug 28 10:42:20 MDT 2007
[EMAIL PROTECTED]:/usr/src/sys/arch/macppc/compile/GENERIC
real mem = 1342177280 (1280MB)
avail mem = 1287536640 (1227MB)
mainbus0 at root: model PowerBook6,8
cpu0 at mainbus0: 7447A (Revision 0x102): 1499 MHz: 512KB L2 cache
memc0 at mainbus0: uni-n
"hw-clock" at memc0 not configured
kiic0 at memc0 offset 0xf8001000
iic0 at kiic0
adt0 at iic0 addr 0x2e: adt7467 rev 0x71
asms0 at iic0 addr 0x58, rev 1.34, version 0.1
mpcpcibr0 at mainbus0 pci: uni-north, Revision 0xff
pci0 at mpcpcibr0 bus 0
pchb0 at pci0 dev 11 function 0 "Apple UniNorth AGP" rev 0x00
vgafb0 at pci0 dev 16 function 0 "NVIDIA GeForce FX Go 5200" rev 0xa1, mmio
wsdisplay0 at vgafb0 mux 1: console (std, vt100 emulation)
mpcpcibr1 at mainbus0 pci: uni-north, Revision 0x5
pci1 at mpcpcibr1 bus 0
pchb1 at pci1 dev 11 function 0 "Apple UniNorth PCI" rev 0x00
"Broadcom BCM4306" rev 0x03 at pci1 dev 18 function 0 not configured
macobio0 at pci1 dev 23 function 0 "Apple Intrepid" rev 0x00
openpic0 at macobio0 offset 0x40000: version 0x4614 little endian
macgpio0 at macobio0 offset 0x50
"modem-reset" at macgpio0 offset 0x1d not configured
"modem-power" at macgpio0 offset 0x1c not configured
"accelerometer-1" at macgpio0 offset 0x13 not configured
"accelerometer-2" at macgpio0 offset 0x14 not configured
"headphone-mute" at macgpio0 offset 0x1f not configured
"amp-mute" at macgpio0 offset 0x20 not configured
"hw-reset" at macgpio0 offset 0x25 not configured
"linein-detect" at macgpio0 offset 0xc not configured
"headphone-detect" at macgpio0 offset 0x17 not configured
macgpio1 at macgpio0 offset 0x9 irq 47
"programmer-switch" at macgpio0 offset 0x11 not configured
"cpu-vcore-select" at macgpio0 offset 0x6b not configured
"gpio4" at macgpio0 offset 0x1e not configured
"escc-legacy" at macobio0 offset 0x12000 not configured
zsc0 at macobio0 offset 0x13000: irq 22,23
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
snapper0 at macobio0 offset 0x0: irq 30,1,2
"timer" at macobio0 offset 0x15000 not configured
adb0 at macobio0 offset 0x16000 irq 25: via-pmu, 2 targets
akbd0 at adb0 addr 2: iBook keyboard with inverted T (ISO layout)
wskbd0 at akbd0: console keyboard, using wsdisplay0
abtn0 at adb0 addr 7: brightness/volume/eject buttons
apm0 at adb0: battery flags 0x5, 98% charged
piic0 at adb0
iic1 at piic0
"battery" at macobio0 offset 0x0 not configured
"backlight" at macobio0 offset 0xf300 not configured
kiic1 at macobio0 offset 0x18000
iic2 at kiic1
wdc0 at macobio0 offset 0x20000 irq 24: DMA
atapiscsi0 at wdc0 channel 0 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <MATSHITA, CD-RW CW-8123, CA14> SCSI0
5/cdrom removable
cd0(wdc0:0:0): using BIOS timings, DMA mode 2
audio0 at snapper0
ohci0 at pci1 dev 24 function 0 "Apple Intrepid USB" rev 0x00: irq 0,
version 1.0, legacy support
ohci1 at pci1 dev 25 function 0 "Apple Intrepid USB" rev 0x00: irq 0,
version 1.0, legacy support
ohci2 at pci1 dev 26 function 0 "Apple Intrepid USB" rev 0x00: irq 29,
version 1.0, legacy support
ohci3 at pci1 dev 27 function 0 "NEC USB" rev 0x43: irq 63, version 1.0
ohci4 at pci1 dev 27 function 1 "NEC USB" rev 0x43: irq 63, version 1.0
ehci0 at pci1 dev 27 function 2 "NEC USB" rev 0x04: irq 63
usb0 at ehci0: USB revision 2.0
uhub0 at usb0: NEC EHCI root hub, rev 2.00/1.00, addr 1
usb1 at ohci0: USB revision 1.0
uhub1 at usb1: Apple OHCI root hub, rev 1.00/1.00, addr 1
usb2 at ohci1: USB revision 1.0
uhub2 at usb2: Apple OHCI root hub, rev 1.00/1.00, addr 1
usb3 at ohci2: USB revision 1.0
uhub3 at usb3: Apple OHCI root hub, rev 1.00/1.00, addr 1
usb4 at ohci3: USB revision 1.0
uhub4 at usb4: NEC OHCI root hub, rev 1.00/1.00, addr 1
usb5 at ohci4: USB revision 1.0
uhub5 at usb5: NEC OHCI root hub, rev 1.00/1.00, addr 1
mpcpcibr2 at mainbus0 pci: uni-north, Revision 0x6
pci2 at mpcpcibr2 bus 0
pchb2 at pci2 dev 11 function 0 "Apple UniNorth PCI" rev 0x00
kauaiata0 at pci2 dev 13 function 0 "Apple Intrepid ATA" rev 0x00
wdc1 at kauaiata0 irq 39: DMA
wd0 at wdc1 channel 0 drive 0: <SAMSUNG HM160JC>
wd0: 16-sector PIO, LBA48, 152627MB, 312581808 sectors
wd0(wdc1:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 5
"Apple UniNorth Firewire" rev 0x81 at pci2 dev 14 function 0 not configured
gem0 at pci2 dev 15 function 0 "Apple Uni-N2 GMAC" rev 0x80: irq 41,
address 00:11:24:da:75:ee
bmtphy0 at gem0 phy 0: BCM5221 100baseTX PHY, rev. 4
Apple Computer ADB device, class 0/0, rev 2.00/19.65, addr 2, uhub3
port 1 not configured
uhidev0 at uhub3 port 2 configuration 1 interface 0
uhidev0: Apple Computer Apple Internal Trackpad, rev 2.00/0.06, addr
3, iclass 3/1
tpms0 at uhidev0: 12 inch PowerBook Trackpad
wsmouse0 at tpms0 mux 0
bootpath: /[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]:/bsd
root on wd0a swap on wd0b dump on wd0b
