On Jan 29, 2008 12:24 AM, Chris <[EMAIL PROTECTED]> wrote:
> I am trying to use hotplugd(8) to mount my USB flash drive (/dev/sd1i)
> automatically in /mn/flash when I plug it it. I enabled hotplugd in
> /etc/rc.conf.local and wrote the following script (chmod +x bit set)
>
> #!/bin/sh
>
> DEVCLASS=$1
> DEVNAME=$2
>
> case $DEVCLASS in
> 2)
> # disk devices
>
> disklabel=`/sbin/disklabel $DEVNAME 2>&1 | \
> sed -n '/^label: /s/^label: //p'`
> case $disklabel in
> flash)
> # flash drive
> mount /dev/"$DEVNAME"i /mnt/flash
> ;;
> esac
> ;;
> 3)
> # network devices
>
> /sbin/dhclient $DEVNAME
>
> ;;
> esac
>
> I can mount the flash drive fine with mount /dev/sd1i /mnt/flash
>
> Any help would be much appreciated. Thanks.
I figured (from /var/log/messages) that the flash drive is mounted as
"JetFlash" so I changed the script to reflect this and still no luck.
Following the /var/log/message after the flash drive is plugged in and
also the new modified script.
Jan 29 19:40:44 red /bsd: sd1 detached
Jan 29 19:40:44 red /bsd: scsibus2 detached
Jan 29 19:40:44 red /bsd: umass0 detached
Jan 29 19:40:47 red /bsd: umass0 at uhub0 port 2 configuration 1 interface 0
Jan 29 19:40:47 red /bsd:
Jan 29 19:40:47 red /bsd: umass0: JetFlash Mass Storage Device, rev
2.00/1.41, addr 2
Jan 29 19:40:47 red /bsd: umass0: using SCSI over Bulk-Only
Jan 29 19:40:47 red /bsd: scsibus2 at umass0: 2 targets
Jan 29 19:40:47 red /bsd: sd1 at scsibus2 targ 1 lun 0: <JetFlash,
TS8GJFV30, 8.07> SCSI2 0/direct removable
Jan 29 19:40:47 red /bsd: sd1: 7799MB, 994 cyl, 255 head, 63 sec, 512
bytes/sec, 15974398 sec total
#!/bin/sh
DEVCLASS=$1
DEVNAME=$2
case $DEVCLASS in
2)
# disk devices
disklabel=`/sbin/disklabel $DEVNAME 2>&1 | \
sed -n '/^label: /s/^label: //p'`
case $disklabel in
JetFlash)
# flash drive
mount /dev/"$DEVNAME"i /mnt/flash
;;
esac
;;
3)
# network devices
/sbin/dhclient $DEVNAME
;;
esac
Is there anything I am doing wrong? Thanks for any help.
