On Jan 17, 2008 1:28 PM, Darrin Chandler <[EMAIL PROTECTED]> wrote: > If the error message is accurate then you're probably bumping up against > the maxproc limit. Default login class is maxproc-cur=64, which is > usually fine. But if you have a lot of processes... > > If that's the problem then see login.conf(5) and either change which > login class you are using (change to staff), or raise the default.
Sorry Darrin, didn't hit reply-to all. I've also seen a similar error when the system reaches the pty limit (lots of screen sessions/terminals). I haven't yet researched how to bump this, but it shouldn't be too difficult to do. HTH, -- # Curt Micol "Today is the tomorrow I was so worried about yesterday." -Anthony Hopkins
