Hi,
Since I kinda needed a stable system, I switched to MSI K9N6GM,
that has NVIDIA MCP61 chipset.
It doesn't at all support AHCI (not that I can tell), but IDE access for SATA
is supported in DMA mode (UDMA5).
nfe interface also seems to be working.
I get 70-80 MBps according to 'dd' (iostat only shows 32MBps)
What is the good rate that can actually be achieved on 3Gbps drives?
And I still get those "no compatible PCI ICU found" and
"unable to fix up PCI interrupts routing" messages...
It was suggested that these messages can be ignored...
On Dec 29, 2007 4:32 AM, Peter Strvmberg <[EMAIL PROTECTED]> wrote:
> On 28 Dec 2007 at 21:29, Pawel Veselov wrote:
>
> > Hi,
> >
> > Just had some experience installing 4.2 on ASUS m2a-vm... Wasn't
pleasant.
>
> Try -current, it will work better, with some gotchas thou.
>
> > 3Gbs drive shows max of 0.2MBs tranfer rate (according to iostat). My
> > old drive shows appx 30MB on IDE bus. Tested using dd if=/dev/zero
> > of=file. Any disk access takes forever.
> The drive is in pio-mode
I couldn't find a way to switch it into DMA mode...
>
> > Selecting SATA interface as AHCI doesn't work (doesn't show up, or
> > reboots the system when discovery attepmted).
>
> In -current you can install to ahci/sata, but then generic doesn't boot.
> You need to boot -c and disable ahci, change fstab to wd and then compile
> a kernel with a KASSERT removed (in dev/pci/ahci.c, line 1757)
> Change fstab again, and reboot. You'll get some ahci warnings, but it will
work
[ skipped ]
> Other quirks, the radeonhd driver doesn't work if you (only) use a dvi
cable.
> With an vga and a dvi cable you can run X
Well, I was mostly venting here, it's great current supports all this
better, but I'd like some peace for this box :)
OpenBSD 4.2 (GENERIC.MP) #252: Tue Aug 28 10:53:04 MDT 2007
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC.MP
cpu0: AMD Athlon(tm) 64 X2 Dual Core Processor 4800+ ("AuthenticAMD"
686-class, 512KB L2 cache) 2.42 GHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CFLUS
H,MMX,FXSR,SSE,SSE2,HTT,SSE3,CX16
real mem = 2079748096 (1983MB)
avail mem = 2003210240 (1910MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 11/29/06, BIOS32 rev. 0 @
0xf0010, SMBIOS rev. 2.5 @ 0xfbda0 (48 entries)
bios0: vendor American Megatrends Inc. version "V1.5" date 11/29/2006
bios0: MSI MS-7309
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
apm0: flags 30102 dobusy 0 doidle 1
pcibios0 at bios0: rev 3.0 @ 0xf0000/0x10000
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf5100/272 (15 entries)
pcibios0: no compatible PCI ICU found: ICU vendor 0x10de product 0x03e0
pcibios0: Warning, unable to fix up PCI interrupt routing
pcibios0: PCI bus #4 is the last bus
bios0: ROM list: 0xc0000/0xee00
mainbus0: Intel MP Specification (Version 1.4)
cpu0 at mainbus0: apid 0 (boot processor)
cpu0: apic clock running at 200 MHz
cpu1 at mainbus0: apid 1 (application processor)
cpu1: AMD Athlon(tm) 64 X2 Dual Core Processor 4800+ ("AuthenticAMD"
686-class, 512KB L2 cache) 2.42 GHz
cpu1:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CFLUS
H,MMX,FXSR,SSE,SSE2,HTT,SSE3,CX16
mainbus0: bus 0 is type PCI
mainbus0: bus 1 is type PCI
mainbus0: bus 2 is type PCI
mainbus0: bus 3 is type PCI
mainbus0: bus 4 is type PCI
mainbus0: bus 5 is type ISA
ioapic0 at mainbus0: apid 2 pa 0xfec00000, version 11, 24 pins
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
"NVIDIA MCP61 Memory" rev 0xa1 at pci0 dev 0 function 0 not configured
pcib0 at pci0 dev 1 function 0 "NVIDIA MCP61 ISA" rev 0xa2
nviic0 at pci0 dev 1 function 1 "NVIDIA MCP61 SMBus" rev 0xa2
iic0 at nviic0
iic1 at nviic0
iic1: addr 0x2f 00=c0 01=0f 02=00 03=01 04=07 05=00 06=18 07=00 08=00
14=14 15=62 16=02 17=05
"NVIDIA MCP61 Memory" rev 0xa2 at pci0 dev 1 function 2 not configured
ohci0 at pci0 dev 2 function 0 "NVIDIA MCP61 USB" rev 0xa2: apic 2 int
5 (irq 5), version 1.0, legacy support
ehci0 at pci0 dev 2 function 1 "NVIDIA MPC61 USB" rev 0xa2: apic 2 int
10 (irq 10)
usb0 at ehci0: USB revision 2.0
uhub0 at usb0: NVIDIA EHCI root hub, rev 2.00/1.00, addr 1
ppb0 at pci0 dev 4 function 0 "NVIDIA MCP61" rev 0xa1
pci1 at ppb0 bus 1
skc0 at pci1 dev 9 function 0 "D-Link Systems DGE-530T B1" rev 0x11,
Yukon Lite(0x9): apic 2 int 10 (irq 10)
sk0 at skc0 port A: address 00:15:e9:bd:30:88
eephy0 at sk0 phy 0: Marvell 88E1011 Gigabit PHY, rev. 5
rl0 at pci1 dev 10 function 0 "Realtek 8139" rev 0x10: apic 2 int 11
(irq 11), address 00:0e:2e:5b:45:90
rlphy0 at rl0 phy 0: RTL internal PHY
azalia0 at pci0 dev 5 function 0 "NVIDIA MCP61 HD Audio" rev 0xa2:
apic 2 int 11 (irq 11)
azalia0: host: High Definition Audio rev. 1.0
azalia0: codec: Realtek ALC883 (rev. 0.2), HDA version 1.0
audio0 at azalia0
pciide0 at pci0 dev 6 function 0 "NVIDIA MCP61 IDE" rev 0xa2: DMA,
channel 0 configured to compatibility, channel 1 configured to
compatibility
wd0 at pciide0 channel 0 drive 0: <HDS722525VLAT80>
wd0: 16-sector PIO, LBA48, 238475MB, 488397168 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 5
pciide0: channel 1 ignored (disabled)
nfe0 at pci0 dev 7 function 0 "NVIDIA MCP61 LAN" rev 0xa2: apic 2 int
5 (irq 5), address 8d:5e:49:db:19:00
rlphy1 at nfe0 phy 1: RTL8201L 10/100 PHY, rev. 1
pciide1 at pci0 dev 8 function 0 "NVIDIA MCP61 SATA" rev 0xa2: DMA
pciide1: using apic 2 int 10 (irq 10) for native-PCI interrupt
wd1 at pciide1 channel 0 drive 0: <Hitachi HDS721075KLA330>
wd1: 16-sector PIO, LBA48, 715404MB, 1465149168 sectors
wd1(pciide1:0:0): using PIO mode 4, Ultra-DMA mode 5
ppb1 at pci0 dev 9 function 0 "NVIDIA MCP61 PCIE" rev 0xa2
pci2 at ppb1 bus 2
ppb2 at pci0 dev 11 function 0 "NVIDIA MCP61 PCIE" rev 0xa2
pci3 at ppb2 bus 3
ppb3 at pci0 dev 12 function 0 "NVIDIA MCP61 PCIE" rev 0xa2
pci4 at ppb3 bus 4
vga1 at pci0 dev 13 function 0 vendor "NVIDIA", unknown product 0x03d1 rev
0xa2
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
pchb0 at pci0 dev 24 function 0 "AMD AMD64 HyperTransport" rev 0x00
pchb1 at pci0 dev 24 function 1 "AMD AMD64 Address Map" rev 0x00
pchb2 at pci0 dev 24 function 2 "AMD AMD64 DRAM Cfg" rev 0x00
pchb3 at pci0 dev 24 function 3 "AMD AMD64 Misc Cfg" rev 0x00
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
usb1 at ohci0: USB revision 1.0
uhub1 at usb1: NVIDIA OHCI root hub, rev 1.00/1.00, addr 1
pctr: user-level cycle counter enabled
mtrr: Pentium Pro MTRR support
apm0: disconnected
uhub2 at uhub1 port 3: Texas Instruments TUSB2046 hub, rev 1.10/1.25, addr 2
uhidev0 at uhub2 port 2 configuration 1 interface 0
uhidev0: Logitech USB Optical Mouse, rev 2.00/43.01, addr 3, iclass 3/1
ums0 at uhidev0: 3 buttons and Z dir.
wsmouse0 at ums0 mux 0
uhidev1 at uhub2 port 1 configuration 1 interface 0
uhidev1: Raptor Gaming product 0x0103, rev 1.10/1.01, addr 4, iclass 3/1
ukbd0 at uhidev1: 8 modifier keys, 6 key codes
wskbd1 at ukbd0 mux 1
wskbd1: connecting to wsdisplay0
uhidev2 at uhub2 port 1 configuration 1 interface 1
uhidev2: Raptor Gaming product 0x0103, rev 1.10/1.01, addr 4, iclass 3/0
uhidev2: 2 report ids
uhid0 at uhidev2 reportid 1: input=2, output=0, feature=0
uhid1 at uhidev2 reportid 2: input=1, output=0, feature=0
dkcsum: wd0 matches BIOS drive 0x81
dkcsum: wd1 matches BIOS drive 0x80
root on wd1a swap on wd1b dump on wd1b
