Curious problem here, though I'm probably missing something obvious. I
have apm enabled through /etc/rc.conf.local (apmd_flags=""), and when I
issue 'shutdown -h -p now', the system powers off correctly. However,
if I try to use sleep or suspend ('apm -S' or 'apm -z'), the system acts
like it's going to power down, blinks the monitor momentarily, then
wakes right back up like nothing ever happened. Where to look next?
# dmesg
OpenBSD 4.2-stable (GENERIC) #0: Fri Dec 7 23:23:20 EST 2007
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: AMD Opteron(tm) Processor 154 ("AuthenticAMD" 686-class, 1024KB
L2 cache) 2.82 GHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CFLUSH,MMX,FXSR,SSE,SSE2,SSE3
cpu0: AMD erratum 89 present, BIOS upgrade may be required
real mem = 535261184 (510MB)
avail mem = 509927424 (486MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 05/30/06, BIOS32 rev. 0 @ 0xfa850,
SMBIOS rev. 2.2 @ 0xf0000 (39 entries)
bios0: vendor Phoenix Technologies, LTD version "6.00 PG" date 05/30/2006
bios0: http://www.abit.com.tw/ KN8 Series(NF-CK804)
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
apm0: flags 70102 dobusy 1 doidle 1
pcibios0 at bios0: rev 3.0 @ 0xf0000/0xcd44
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfcc30/240 (13 entries)
pcibios0: bad IRQ table checksum
pcibios0: PCI BIOS has 15 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 3 5 7 10 11
pcibios0: no compatible PCI ICU found
pcibios0: Warning, unable to fix up PCI interrupt routing
pcibios0: PCI bus #7 is the last bus
bios0: ROM list: 0xc0000/0x8000 0xc8000/0x1000
cpu0 at mainbus0
cpu0: Cool'n'Quiet K8 2814 MHz: speeds: 2800 2600 2400 2200 2000 1800
1000 MHz
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
"NVIDIA nForce4 DDR" rev 0xa3 at pci0 dev 0 function 0 not configured
pcib0 at pci0 dev 1 function 0 "NVIDIA nForce4 ISA" rev 0xa3
nviic0 at pci0 dev 1 function 1 "NVIDIA nForce4 SMBus" rev 0xa2
iic0 at nviic0
iic0: addr 0x2e 00=00 01=00 02=00 03=00 04=a1 05=07 06=00 07=00
iic1 at nviic0
ohci0 at pci0 dev 2 function 0 "NVIDIA nForce4 USB" rev 0xa2: irq 11,
version 1.0, legacy support
ehci0 at pci0 dev 2 function 1 "NVIDIA nForce4 USB" rev 0xa3: irq 3
usb0 at ehci0: USB revision 2.0
uhub0 at usb0: NVIDIA EHCI root hub, rev 2.00/1.00, addr 1
pciide0 at pci0 dev 6 function 0 "NVIDIA nForce4 IDE" rev 0xf2: DMA,
channel 0 configured to compatibility, channel 1 configured to compatibility
atapiscsi0 at pciide0 channel 0 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <SONY, DVD-ROM DDU1615, GYS4> SCSI0
5/cdrom removable
cd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 4
pciide0: channel 1 ignored (disabled)
pciide1 at pci0 dev 7 function 0 "NVIDIA nForce4 SATA" rev 0xf3: DMA
pciide1: using irq 11 for native-PCI interrupt
wd0 at pciide1 channel 0 drive 0: <WDC WD800JD-00LSA0>
wd0: 16-sector PIO, LBA48, 76319MB, 156301488 sectors
wd0(pciide1:0:0): using PIO mode 4, Ultra-DMA mode 5
ppb0 at pci0 dev 9 function 0 "NVIDIA nForce4 PCI-PCI" rev 0xa2
pci1 at ppb0 bus 1
vga1 at pci1 dev 8 function 0 "S3 ViRGE DX/GX" rev 0x01
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
nfe0 at pci0 dev 10 function 0 "NVIDIA CK804 LAN" rev 0xa3: irq 5,
address 00:50:8d:83:09:e7
ciphy0 at nfe0 phy 1: Cicada CS8201 10/100/1000TX PHY, rev. 3
ppb1 at pci0 dev 11 function 0 "NVIDIA nForce4 PCIE" rev 0xa3
pci2 at ppb1 bus 2
ppb2 at pci0 dev 12 function 0 "NVIDIA nForce4 PCIE" rev 0xa3
pci3 at ppb2 bus 3
ppb3 at pci0 dev 13 function 0 "NVIDIA nForce4 PCIE" rev 0xa3
pci4 at ppb3 bus 4
ppb4 at pci0 dev 14 function 0 "NVIDIA nForce4 PCIE" rev 0xa3
pci5 at ppb4 bus 5
ppb5 at pci5 dev 0 function 0 "Intel IOP333 PCIE-PCIX" rev 0x00
pci6 at ppb5 bus 6
arc0 at pci6 dev 14 function 0 "Areca ARC-1220" rev 0x00: irq 10
arc0: 8 SATA Ports, 256MB SDRAM, FW Version: V1.43 2007-4-17
scsibus1 at arc0: 16 targets
sd0 at scsibus1 targ 0 lun 0: <Areca, ARC-1220-VOL#00, R001> SCSI3
0/direct fixed
sd0: 858306MB, 61035 cyl, 60 head, 480 sec, 512 bytes/sec, 1757812224
sec total
sd1 at scsibus1 targ 0 lun 1: <Areca, ARC-1220-VOL#01, R001> SCSI3
0/direct fixed
sd1: 457882MB, 61051 cyl, 32 head, 480 sec, 512 bytes/sec, 937743360 sec
total
ppb6 at pci5 dev 0 function 2 "Intel IOP333 PCIE-PCIX" rev 0x00
pci7 at ppb6 bus 7
pchb0 at pci0 dev 24 function 0 "AMD AMD64 HyperTransport" rev 0x00
pchb1 at pci0 dev 24 function 1 "AMD AMD64 Address Map" rev 0x00
pchb2 at pci0 dev 24 function 2 "AMD AMD64 DRAM Cfg" rev 0x00
pchb3 at pci0 dev 24 function 3 "AMD AMD64 Misc Cfg" rev 0x00
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
lm0 at isa0 port 0x290/8: W83627HF
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
usb1 at ohci0: USB revision 1.0
uhub1 at usb1: NVIDIA OHCI root hub, rev 1.00/1.00, addr 1
biomask ffcd netmask ffed ttymask ffef
pctr: user-level cycle counter enabled
mtrr: Pentium Pro MTRR support
uhidev0 at uhub1 port 6 configuration 1 interface 0
uhidev0: vendor 0x0603 USB Mouse STD., rev 1.00/1.00, addr 2, iclass 3/1
ums0 at uhidev0: 3 buttons
wsmouse0 at ums0 mux 0
dkcsum: wd0 matches BIOS drive 0x80
dkcsum: sd0 matches BIOS drive 0x81
dkcsum: sd1 matches BIOS drive 0x82
root on wd0a swap on wd0b dump on wd0b
