Recently we were building a couple new amd64 machines and purchased a couple
LSI 8204XLP's on the speculation that they would be supported in 4.2 (though
only their bigger brother the 8208XLP was listed explicitly).

Only slightly to our surprise did we discover that the 8204XLP's would not
work.  The device would be found, but instead of the RAID1 logical disk, it
would report the two physical disks (RAID firmware configuration was
checked/rechecked/checkedsomemore).  We tried installing the OS on the low
order disk just to see what would happen.  The OS would install, but on
subsequent boot would fail at the "root device:" stage.

Feeling a certain amount of shame in defying the HCL, we purchased 8208XLPs
as a replacement.  These failed in exactly the same way.  It turns out that
they really are brothers in the sense that the 8204 is an 8208 card with a
blank spot where the second connector would be.

Then we decided to try 4.2 release (we were using -current), and the
drive(s) are not seen at all by the OS installer for 4.2.  We then switched
to a newer -current (from Nov. 1) and ran into the same problem as the
previous attempts with -current.

In some looking though, we see that the card appears to be identified with
the mpi driver instead of the mfi driver as it should, at least according to
mfi(4).

We now have two of each card here that aren't useful to us in the near term,
so we would be happy to send one of each of them along to the driver dev if
it would help future development.

The rest of this message is the dmesg from booting off the Nov 1 -current.

OpenBSD 4.2-current (RAMDISK_CD) #1295: Thu Nov  1 19:18:55 MDT 2007
    [EMAIL PROTECTED]:/usr/src/sys/arch/amd64/compile/RAMDISK_CD
real mem = 2146996224 (2047MB)
avail mem = 2075045888 (1978MB)
mainbus0 at root
acpi at mainbus0 not configured
cpu0 at mainbus0: (uniprocessor)
cpu0: Dual-Core AMD Opteron(tm) Processor 2212, 2010.58 MHz
cpu0: 
FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CFLU
SH,MMX,FXSR,SSE,SSE2,HTT,SSE3,CX16,NXE,MMXX,FFXSR,LONG,3DNOW2,3DNOW
cpu0: 64KB 64b/line 2-way I-cache, 64KB 64b/line 2-way D-cache, 1MB 64b/line
16-way L2 cache
cpu0: ITLB 32 4KB entries fully associative, 8 4MB entries fully associative
cpu0: DTLB 32 4KB entries fully associative, 8 4MB entries fully associative
pci0 at mainbus0 bus 0: configuration mode 1
"NVIDIA MCP55 Memory" rev 0xa2 at pci0 dev 0 function 0 not configured
"NVIDIA MCP55 ISA" rev 0xa3 at pci0 dev 1 function 0 not configured
"NVIDIA MCP55 SMBus" rev 0xa3 at pci0 dev 1 function 1 not configured
ohci0 at pci0 dev 2 function 0 "NVIDIA MCP55 USB" rev 0xa1: irq 7, version
1.0, legacy support
ehci0 at pci0 dev 2 function 1 "NVIDIA MCP55 USB" rev 0xa2: irq 10
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "NVIDIA EHCI root hub" rev 2.00/1.00 addr 1
pciide0 at pci0 dev 4 function 0 "NVIDIA MCP55 IDE" rev 0xa1: DMA, channel 0
configured to compatibility, channel 1 configured to compatibility
atapiscsi0 at pciide0 channel 0 drive 1
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <TEAC, DW-224E-V, 1.CA> SCSI0 5/cdrom
removable
cd0(pciide0:0:1): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 ignored (disabled)
pciide1 at pci0 dev 5 function 0 "NVIDIA MCP55 SATA" rev 0xa3: DMA
pciide1: using irq 11 for native-PCI interrupt
pciide2 at pci0 dev 5 function 1 "NVIDIA MCP55 SATA" rev 0xa3: DMA
pciide2: using irq 5 for native-PCI interrupt
pciide3 at pci0 dev 5 function 2 "NVIDIA MCP55 SATA" rev 0xa3: DMA
pciide3: using irq 10 for native-PCI interrupt
ppb0 at pci0 dev 6 function 0 "NVIDIA MCP55 PCI-PCI" rev 0xa2
pci1 at ppb0 bus 1
vga1 at pci1 dev 6 function 0 "ATI ES1000" rev 0x02
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
nfe0 at pci0 dev 8 function 0 "NVIDIA MCP55 LAN" rev 0xa3: irq 10, address
00:30:48:7c:97:22
eephy0 at nfe0 phy 2: Marvell 88E1149 Gigabit PHY, rev. 1
nfe1 at pci0 dev 9 function 0 "NVIDIA MCP55 LAN" rev 0xa3: irq 11, address
00:30:48:7c:97:23
eephy1 at nfe1 phy 3: Marvell 88E1149 Gigabit PHY, rev. 1
ppb1 at pci0 dev 10 function 0 "NVIDIA MCP55 PCIE" rev 0xa3
pci2 at ppb1 bus 2
ppb2 at pci2 dev 0 function 0 "NEC PCIE-PCIX" rev 0x07
pci3 at ppb2 bus 3
ppb3 at pci2 dev 0 function 1 "NEC PCIE-PCIX" rev 0x07
pci4 at ppb3 bus 4
mpi0 at pci4 dev 6 function 0 "Symbios Logic SAS1068" rev 0x02: irq 5
scsibus1 at mpi0: 173 targets
sd0 at scsibus1 targ 0 lun 0: <ATA, WDC WD1600YS-01S, 6C06> SCSI3 0/direct
fixed
sd0: 157066MB, 157067 cyl, 16 head, 127 sec, 512 bytes/sec, 321672960 sec
total
sd1 at scsibus1 targ 1 lun 0: <ATA, WDC WD1600YS-01S, 6C06> SCSI3 0/direct
fixed
sd1: 157066MB, 157067 cyl, 16 head, 127 sec, 512 bytes/sec, 321672960 sec
total
ppb4 at pci0 dev 13 function 0 "NVIDIA MCP55 PCIE" rev 0xa3
pci5 at ppb4 bus 5
ppb5 at pci0 dev 14 function 0 "NVIDIA MCP55 PCIE" rev 0xa3
pci6 at ppb5 bus 6
ppb6 at pci0 dev 15 function 0 "NVIDIA MCP55 PCIE" rev 0xa3
pci7 at ppb6 bus 7
pchb0 at pci0 dev 24 function 0 "AMD AMD64 HyperTransport" rev 0x00
pchb1 at pci0 dev 24 function 1 "AMD AMD64 Address Map" rev 0x00
pchb2 at pci0 dev 24 function 2 "AMD AMD64 DRAM Cfg" rev 0x00
pchb3 at pci0 dev 24 function 3 "AMD AMD64 Misc Cfg" rev 0x00
pchb4 at pci0 dev 25 function 0 "AMD AMD64 HyperTransport" rev 0x00
pchb5 at pci0 dev 25 function 1 "AMD AMD64 Address Map" rev 0x00
pchb6 at pci0 dev 25 function 2 "AMD AMD64 DRAM Cfg" rev 0x00
pchb7 at pci0 dev 25 function 3 "AMD AMD64 Misc Cfg" rev 0x00
usb1 at ohci0: USB revision 1.0
uhub1 at usb1 "NVIDIA OHCI root hub" rev 1.00/1.00 addr 1
isa0 at mainbus0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
rd0: fixed, 4480 blocks
umass0 at uhub0 port 2 configuration 1 interface 0 "Crucial Gizmo" rev
2.00/0.50 addr 2
umass0: using SCSI over Bulk-Only
scsibus2 at umass0: 2 targets
sd2 at scsibus2 targ 1 lun 0: <Crucial, Gizmo, 1.13> SCSI0 0/direct
removable
sd2: 495MB, 63 cyl, 255 head, 63 sec, 512 bytes/sec, 1014784 sec total
uhidev0 at uhub1 port 1 configuration 1 interface 0 "DELL DELL USB Keyboard"
rev 1.10/1.04 addr 2
uhidev0: iclass 3/1
ukbd0 at uhidev0
wskbd1 at ukbd0 mux 1
wskbd1: connecting to wsdisplay0
dkcsum: sd0 matches BIOS drive 0x80
root on rd0a swap on rd0b dump on rd0b
WARNING: R/W mount of /mnt denied.  Filesystem is not clean - run fsck


;P mn

--
Preston M Norvell <[EMAIL PROTECTED]>
Systems/Network Administrator
Serials Solutions <http://www.serialssolutions.com>
Phone:  (866) SERIALS (737-4257) ext 1094

Reply via email to