I'm not sure if this made it before my subscription was confirmed, so I'm
posting it again (1.5 hours later).
----- Forwarded by Hammond Mason/GB/ABNAMRO/NL on 21/11/2007 14:23 -----
Hammond
Mason/GB/ABNAMRO/
NL To
misc@openbsd.org
21/11/2007 12:59 cc
Subject
IPoEoA on ueagle?
I am running 4.2-RELEASE and have recompiled the kernel to include the
lines:
Option NATM
ueagle* at usb?
My Sagem [EMAIL PROTECTED] 800 E2 is recognised by the kernel:
# dmesg | grep ueagle
ueagle0 at uhub3 port 2
ueagle0 detached
ueagle0 at uhub3 port 2
ueagle0: Analog Devices Eagle II, rev 1.00/50.0b, addr 2
ueagle0: address: 00:60:4c:16:d1:60
#
My ISP uses IPoEoA.
I have done a bit of reading on ATM (although I am by no means an expert)
and I would like to know if IPoEoA is supported in ueagle.
Can anyone please tell me if this is the case and, if so, is there any
special configuration advice they can give me?
Kind regards
---------------------------------------------------------------------------
This message (including any attachments) is confidential and may be
privileged. If you have received it by mistake please notify the sender by
return e-mail and delete this message from your system. Any unauthorised
use or dissemination of this message in whole or in part is strictly
prohibited. Please note that e-mails are susceptible to change. ABN AMRO
Bank N.V, which has its seat at Amsterdam, the Netherlands, and is
registered in the Commercial Register under number 33002587, including its
group companies, shall not be liable for the improper or incomplete
transmission of the information contained in this communication nor for any
delay in its receipt or damage to your system. ABN AMRO Bank N.V. (or its
group companies) does not guarantee that the integrity of this
communication has been maintained nor that this communication is free of
viruses, interceptions or interference.
---------------------------------------------------------------------------
