Jan Stary wrote:
On Nov 05 16:24:53, Michael wrote:
I installed a back-up hd (from different computer) into a computer that
I haven't used for some time. It had openbsd-4.1 (generic kernel)
installed.
I assume that the drive you just inserted is the only one in that
box, and you are booting from this drive. Please confirm, or give
some description of what drives are in the box and which one you are
booting from.
I booted and the system hung after probing floppy drive. Last line
I see: fd0 at fdc0 drive 0: 1.44MB 80cyl, 2 head, 18 sec I re-booted
and the same thing. I let the system run for 15 minutes to see if it
would finish. It didn't I rebooted with 4.2 install cd that I used to
install 4.2 on a different computer, and upgraded 4.1 to 4.2.
Everything went well till I rebooted and the system hung/froze at the
exact same spot. Thinking something was amiss in /etc, I rebooted with
cd, and did a fresh install after deleting / and swap partition.
Installation went smooth, and then I rebooted. 4.2 (Generic)
hung/froze at the same line again. I rebooted and disabled usb in cmos
to see if that would correct the problem. It didn't.
Why would it? It's fdc that is making it freeze, not USB.
Disable fdc in the kernel via UKC:
I heard the system probe the floppy drive, so thinking it was done with
that, the next 2 lines in sequence are:
usb1 at ohci1: USB revision 1.0
uhub1 at usb1: Acer Labs OHCI root hub, rev 1.00/1.00, addr 1
I thought that is where the system was hanging/freezing/ in a
loop/whatever :)
boot -c
disable fdc*
boot
Will try that now. Thanks.
Re-booting again, I booted with bsd.rd and the system booted fine. At
the prompt, I selected "s", mounted my wd0a partition and a linux
partition, copied the "messages" and "dmesg.boot" files to the linux
partition.
What linux partition?
the linux partition/system (debian) that i am on now to write about the
problem
Which file would be helpful? I can add either file or both, but
again, they are 17k
Do a clean install of 4.2, and save the output
of dmesg just before you halt-and-reboot (obviously,
save it somewhere outside the box.)
Then halt-and-reboot, see if it hangs. If it does not,
save the complete dmesg again. If it does, try disabling
fdc as shown above; if it boots now, save the dmesg
(and make the change to your kernel permanent via config(8)).
Then study the difference between the two dmesg's carefully,
and send both dmesg's to the list.
Jan
Will do that after trying the disable fdc*
Thanks!
