Hello

I have the following issue with ralink wireless card, acting in hostap 
mode

> hardware: ral-rt2561s board acting as access point on a Soekris 
> Net4501, running OpenBSD 4.0.


can't seem to make it work like it should, even with a 9dBi antenna the 
signal is very weak and much weaker than my old netgear AP. weak and 
unstable

everything is set up correctly

# dmesg | grep ral0
ral0 at pci0 dev 16 function 0 "Ralink RT2561S" rev 0x00: irq 10, 
address 00:12:0e:61:80:98
ral0: MAC/BBP RT2561C, RF RT5225


ral0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
         lladdr 00:12:0e:61:80:98
         media: IEEE802.11 autoselect hostap (autoselect mode 11a hostap)
         status: active
         ieee80211: nwid xxx chan 11 bssid 00:12:0e:61:80:98 nwkey xxxx 
100dBm
         inet 192.168.x.x netmask 0xffffff00 broadcast 192.168.x.xxx
         inet6 fe80::212:eff:fe61:8098%ral0 prefixlen 64 scopeid 0x1

but it seems it's all working at very small % of its power.
question is: is this a known bug in the driver?? or is there anything I 
could do to improve the situation?

Thanks,

Alessandro
Soekris docs & rulesets http://sekureshell.altervista.org

Reply via email to