Hi, I've just successfully installed OpenBSD 4.0 on a net4801-60 with a lan1641 Ethernet PCI board and a SAN Extreme III 2GB CF.
The installation completed flawlessly after I disabled pciide at the UKC prompt. The problem is now that I'm trying to boot the net4801 but the boot always hangs with: ################# Boot output start ##################### comBIOS ver. 1.28 20050529 Copyright (C) 2000-2005 Soekris Engineering. net4801 0256 Mbyte Memory CPU Geode 266 Mhz Pri Mas SanDisk SDCFX-2048 LBA Xlt 992-64-63 2001 Mbyte Slot Vend Dev ClassRev Cmd Stat CL LT HT Base1 Base2 Int ------------------------------------------------------------------- 0:00:0 1078 0001 06000000 0107 0280 00 00 00 00000000 00000000 0:06:0 100B 0020 02000000 0107 0290 00 3F 00 0000E101 A0000000 10 0:07:0 100B 0020 02000000 0107 0290 00 3F 00 0000E201 A0001000 10 0:08:0 100B 0020 02000000 0107 0290 00 3F 00 0000E301 A0002000 10 0:10:0 104C AC23 06040002 0107 0210 08 3F 01 00000000 00000000 0:18:2 100B 0502 01018001 0005 0280 00 00 00 00000000 00000000 0:19:0 0E11 A0F8 0C031008 0117 0280 08 38 00 A0003000 00000000 11 1:00:0 100B 0020 02000000 0107 0290 00 3F 00 0000D001 A4000000 05 1:01:0 100B 0020 02000000 0107 0290 00 3F 00 0000D101 A4001000 11 1:02:0 100B 0020 02000000 0107 0290 00 3F 00 0000D201 A4002000 05 1:03:0 100B 0020 02000000 0107 0290 00 3F 00 0000D301 A4003000 11 1 Seconds to automatic boot. Press Ctrl-P for entering Monitor. Using drive 0, partition 3. Loading... probing: pc0 com0 com1 mem[639K 255M a20=on] disk: hd0+ >> OpenBSD/i386 BOOT 2.10 boot> booting hd0a:/bsd: 5515872+867984 [52+274160+255770]=0x6980a4 entry point at 0x200120 ################# Boot output end ##################### I've tried two different CF cards (both the same kind of SAN card) but to no avail. They both hang at the same place during boot. Any clues? Thanks a lot in advance, jules
