Hi
I've got a ne2000 based Card which shows up as ne1 (BNC) and ne3 (RJ45).
Unter linux I can assign an ip address to a bridge:
brctl show
bridge name bridge id STP enabled interfaces
br0 8000.0016b6a3ee35 no vlan0
eth1
ifconfig br0
br0 Link encap:Ethernet HWaddr 00:16:B6:A3:EE:35
inet addr:10.0.0.2 Bcast:10.0.0.255 Mask:255.255.255.0
inet6 addr: fe80::216:b6ff:fea3:ee35/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:6276 errors:0 dropped:0 overruns:0 frame:0
TX packets:4805 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:395441 (386.1 KiB) TX bytes:617692 (603.2 KiB)
route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 br0
0.0.0.0 10.0.0.1 0.0.0.0 UG 0 0 0 br0
so there's no routing issue with having eg. 10.0.0.100 connected via BNC and
10.0.0.101 via RJ45.
But under 4.0 I am not allowed to assign an ip:
# ifconfig bridge0 create
# brconfig bridge0 add ne1 add ne3
# ifconfig bridge0 10.4.19.1
ifconfig: SIOCAIFADDR: Invalid argument
Is my idea totally wrong?
--
Greetings
Chris
