I have a Dell 2950, and I'm trying to install the amd64 port of 4.0 release. Install goes fine until the card tries to get an IP address from dhcp. Then I get: Fatal protection fault in supervisor mode. Trap type 4 code 0 ripffffffff802c279c cs 8 rflags 10286 cr 2 4a8f40 cpl 7 rsp ffff80006bea7c50 Syncing disks...done The operating system has halted.
The system only has 2BG of RAM at this point, so I know that 64bit isn't needed, but I thought it would be fun to test. This message to misc@ says that the 2950 is fully supported, but maybe just in i386. http://marc.theaimsgroup.com/?l=openbsd-misc&m=116293042602445&w=2 Perhaps there is a kernel config that I can do to at least get it installed. Any ideas? -- Will Backman Network Administrator Coastal Enterprises, Inc.
