On Sun, 17 Dec 2006 17:19:02 +0100 Alexandre Ratchov <[EMAIL PROTECTED]> wrote:
> On Fri, Dec 15, 2006 at 04:29:31PM -0800, Ben Calvert wrote: > > using the current snapshot from 12/14 on Macppc, using a Tibook 400, > > using mixerctl to set the output volumes to 0 results in low volume, > > instead of no volume. > > > > > > $ mixerctl -a > > outputs.select=speaker > > outputs.speaker=0,0 > > outputs.headphones=0,0 > > source=cd > > master=0,0 > > > > What else should I be looking at? > > mixerctl is supposed to do the job (provided that your device > supports it). > > are you using an USB device? Nope. just the on-board stuff. > could you provide contents of /var/run/dmesg.boot [ using 360300 bytes of bsd ELF symbol table ] console out [ATY,RageM3p12A]console in [keyboard] ADB found using parent ATY,RageM3p12Parent:: memaddr b4000000 size 4000000, : consaddr b6008000, : ioaddr b0020000, size 20000: memtag 8000, iotag 8000: width 1152 linebytes 1280 height 768 depth 8 Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2006 OpenBSD. All rights reserved. http://www.OpenBSD.org OpenBSD 4.0-current (GENERIC) #1128: Thu Dec 14 18:36:52 MST 2006 [EMAIL PROTECTED]:/usr/src/sys/arch/macppc/compile/GENERIC real mem = 536870912 (524288K) avail mem = 481820672 (470528K) using 1254 buffers containing 26841088 bytes (26212K) of memory mainbus0 (root): model PowerBook3,2 cpu0 at mainbus0: 7410 (Revision 0x1103): 500 MHz: 1MB backside cache memc0 at mainbus0: uni-n ki2c0 at memc0 offset 0xf8001000 iic0 at ki2c0 mpcpcibr0 at mainbus0 pci: uni-north, Revision 0xff pci0 at mpcpcibr0 bus 0 pchb0 at pci0 dev 11 function 0 "Apple Uni-N AGP" rev 0x00 vgafb0 at pci0 dev 16 function 0 "ATI Mobility M3" rev 0x02, mmio wsdisplay0 at vgafb0 mux 1: console (std, vt100 emulation) mpcpcibr1 at mainbus0 pci: uni-north, Revision 0x0 pci1 at mpcpcibr1 bus 0 pchb1 at pci1 dev 11 function 0 "Apple Uni-N" rev 0x00 macobio0 at pci1 dev 23 function 0 "Apple Keylargo" rev 0x03 openpic0 at macobio0 offset 0x40000: version 0x4614 macgpio0 at macobio0 offset 0x50 macgpio1 at macgpio0 irq 47 "programmer-switch" at macgpio0 not configured "firewire-linkon" at macgpio0 not configured "escc-legacy" at macobio0 offset 0x12000 not configured zsc0 at macobio0 offset 0x13000: irq 22,23 zstty0 at zsc0 channel 0 zstty1 at zsc0 channel 1 awacs0 at macobio0 offset 0x14000: irq 24,9,10 speaker audio0 at awacs0 "timer" at macobio0 offset 0x15000 not configured adb0 at macobio0 offset 0x16000 irq 25: via-pmu, 3 targets akbd0 at adb0 addr 2: PowerBook G4 keyboard (Inverted T) wskbd0 at akbd0: console keyboard, using wsdisplay0 ams0 at adb0 addr 3: EMP trackpad <tpad> 2-button, 400 dpi wsmouse0 at ams0 mux 0 abtn0 at adb0 addr 7: brightness/volume/eject buttons apm0 at adb0: battery flags 0x5, 99% charged "battery" at macobio0 offset 0x0 not configured "backlight" at macobio0 offset 0xf300 not configured ki2c1 at macobio0 offset 0x18000 iic1 at ki2c1 wdc0 at macobio0 offset 0x1f000 irq 19: DMA wd0 at wdc0 channel 0 drive 0: <HITACHI_DK23EB-40> wd0: 16-sector PIO, LBA, 38154MB, 78140160 sectors wd0(wdc0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4 wdc1 at macobio0 offset 0x20000 irq 20: DMA atapiscsi0 at wdc1 channel 0 drive 0 scsibus0 at atapiscsi0: 2 targets cd0 at scsibus0 targ 0 lun 0: <MATSHITA, DVD-ROM SR-8187, HA18> SCSI0 5/ cdrom removable cd0(wdc1:0:0): using BIOS timings, DMA mode 2 wdc2 at macobio0 offset 0x21000 irq 21: DMA wi0 at macobio0 offset 0x30000 irq 57: wi0: Firmware 8.70 variant 1, address 00:30:65:02:3b:54 ohci0 at pci1 dev 24 function 0 "Apple USB" rev 0x00: irq 27, version 1.0 usb0 at ohci0: USB revision 1.0 uhub0 at usb0 uhub0: Apple OHCI root hub, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered ohci1 at pci1 dev 25 function 0 "Apple USB" rev 0x00: irq 28, version 1.0 usb1 at ohci1: USB revision 1.0 uhub1 at usb1 uhub1: Apple OHCI root hub, rev 1.00/1.00, addr 1 uhub1: 2 ports with 2 removable, self powered cbb0 at pci1 dev 26 function 0 "TI PCI1211 CardBus" rev 0x00: irq 58 cardslot0 at cbb0 slot 0 flags 0 cardbus0 at cardslot0: bus 1 device 0 cacheline 0x8, lattimer 0x20 pcmcia0 at cardslot0 mpcpcibr2 at mainbus0 pci: uni-north, Revision 0x16 pci2 at mpcpcibr2 bus 0 pchb2 at pci2 dev 11 function 0 "Apple Uni-N Eth" rev 0x00 "Apple Uni-N Eth Firewire" rev 0x01 at pci2 dev 14 function 0 not configured gem0 at pci2 dev 15 function 0 "Apple Uni-N GMAC" rev 0x01: irq 41, address 00:03:93:87:be:52 bmtphy0 at gem0 phy 0: BCM5221 100baseTX PHY, rev. 3 uhidev0 at uhub0 port 1 configuration 1 interface 0 uhidev0: Kensington Kensington Expert Mouse, rev 1.10/1.00, addr 2, iclass 3/1 ums0 at uhidev0: 4 buttons and Z dir. wsmouse1 at ums0 mux 0 bootpath: '/[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]/bsd' boot device: wd0. root on wd0a rootdev=0x0 rrootdev=0xb00 rawdev=0xb02 > and the output of 'audioctl -a' ? name=AWACS version= config=awacs encodings=slinear:16,slinear_be:16,slinear_le:16,mulaw:8*,alaw:8*,ulinear:16*,ulinear_le:16*,ulinear_be:16* properties=full_duplex full_duplex=0 fullduplex=0 blocksize=8192 hiwat=8 lowat=1 monitor_gain=0 mode= play.rate=44100 play.channels=2 play.precision=16 play.encoding=slinear_be play.gain=72 play.balance=0 play.port=0x0 play.avail_ports=0x0 play.seek=8192 play.samples=3612672 play.eof=0 play.pause=0 play.error=1 play.waiting=0 play.open=0 play.active=0 play.buffer_size=65536 record.rate=44100 record.channels=2 record.precision=16 record.encoding=slinear_be record.gain=72 record.balance=0 record.port=0x0 record.avail_ports=0x0 record.seek=0 record.samples=0 record.eof=0 record.pause=0 record.error=0 record.waiting=0 record.open=0 record.active=0 record.buffer_size=65536 record.errors=0 > -- Alexandre Thanks, Ben
