This[1] is from a LE-565 board which refuse to run normally when 2 or
more network are attached to more then one re(4).
As soon as i configure and connect an Ethernet cable to a second nic i
get the "watchdog timeout" error at the bottom of the dmesg. No matter
if i put traffic on wire or not.

BTW with recents current SpeedStep has gained two more clock steps.

Any hint is really appreciated.

--
Massimo.run();




[1]
OpenBSD 4.0-current (GENERIC) #1238: Mon Nov 27 07:21:29 MST 2006
    [EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: VIA Esther processor 1000MHz ("CentaurHauls" 686-class) 1 GHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,CMOV,PAT,CFLUSH,ACPI,MMX,FXSR,SSE,SSE2,TM,SBF,SSE3,EST,TM2
cpu0: Enhanced SpeedStep 1000 MHz (844 mV): speeds: 1000, 800, 600, 400
MHz
cpu0: RNG AES AES-CTR SHA1 SHA256 RSA
real mem  = 468152320 (457180K)
avail mem = 418914304 (409096K)
using 4256 buffers containing 23531520 bytes (22980K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(d2) BIOS, date 06/26/06, BIOS32 rev. 0 @
0xf9ed0, SMBIOS rev. 2.3 @ 0xf0000 (33 entries)
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
apm0: flags 70102 dobusy 1 doidle 1
pcibios0 at bios0: rev 2.1 @ 0xf0000/0xd274
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfd180/224 (12 entries)
pcibios0: bad IRQ table checksum
pcibios0: PCI BIOS has 13 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 10
pcibios0: PCI Interrupt Router at 000:17:0 ("VIA VT8237 ISA" rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0xd800! 0xd0000/0x1000
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "VIA CN700 Host" rev 0x00
pchb1 at pci0 dev 0 function 1 "VIA CN700 Host" rev 0x00
pchb2 at pci0 dev 0 function 2 "VIA CN700 Host" rev 0x00
pchb3 at pci0 dev 0 function 3 "VIA PT890 Host" rev 0x00
pchb4 at pci0 dev 0 function 4 "VIA CN700 Host" rev 0x00
pchb5 at pci0 dev 0 function 7 "VIA CN700 Host" rev 0x00
ppb0 at pci0 dev 1 function 0 "VIA VT8377 AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "VIA S3 Unichrome PRO IGP" rev 0x01:
aperture at 0xf4000000, size 0x10000000
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
rtw0 at pci0 dev 10 function 0 "Realtek 8185" rev 0x20: irq 10
rtw0: ver RTL8185, 
rtw0: could not recall EEPROM in 10000us

rtw0: could not recall EEPROM in 10000us
re0 at pci0 dev 11 function 0 "Realtek 8169" rev 0x10: irq 10, address
00:03:1d:03:97:bd
rgephy0 at re0 phy 7: RTL8169S/8110S PHY, rev. 0
re1 at pci0 dev 12 function 0 "Realtek 8169" rev 0x10: irq 10, address
00:03:1d:03:97:be
rgephy1 at re1 phy 7: RTL8169S/8110S PHY, rev. 0
re2 at pci0 dev 13 function 0 "Realtek 8169" rev 0x10: irq 10, address
00:03:1d:03:97:bf
rgephy2 at re2 phy 7: RTL8169S/8110S PHY, rev. 0
re3 at pci0 dev 14 function 0 "Realtek 8169" rev 0x10: irq 10, address
00:03:1d:03:97:c0
rgephy3 at re3 phy 7: RTL8169S/8110S PHY, rev. 0
pciide0 at pci0 dev 15 function 0 "VIA VT6420 SATA" rev 0x80: DMA
pciide0: using irq 10 for native-PCI interrupt
pciide1 at pci0 dev 15 function 1 "VIA VT82C571 IDE" rev 0x06: ATA133,
channel 0 configured to compatibility, channel 1 configured to
compatibility
wd0 at pciide1 channel 0 drive 0: <IBM-DTLA-307030>
wd0: 16-sector PIO, LBA, 29314MB, 60036480 sectors
wd0(pciide1:0:0): using PIO mode 4, Ultra-DMA mode 5
pciide1: channel 1 disabled (no drives)
uhci0 at pci0 dev 16 function 0 "VIA VT83C572 USB" rev 0x81: irq 10
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: VIA UHCI root hub, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1 at pci0 dev 16 function 1 "VIA VT83C572 USB" rev 0x81: irq 10
usb1 at uhci1: USB revision 1.0
uhub1 at usb1
uhub1: VIA UHCI root hub, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhci2 at pci0 dev 16 function 2 "VIA VT83C572 USB" rev 0x81: irq 10
usb2 at uhci2: USB revision 1.0
uhub2 at usb2
uhub2: VIA UHCI root hub, rev 1.00/1.00, addr 1
uhub2: 2 ports with 2 removable, self powered
uhci3 at pci0 dev 16 function 3 "VIA VT83C572 USB" rev 0x81: irq 10
usb3 at uhci3: USB revision 1.0
uhub3 at usb3
uhub3: VIA UHCI root hub, rev 1.00/1.00, addr 1
uhub3: 2 ports with 2 removable, self powered
ehci0 at pci0 dev 16 function 4 "VIA VT6202 USB" rev 0x86: irq 10
usb4 at ehci0: USB revision 2.0
uhub4 at usb4
uhub4: VIA EHCI root hub, rev 2.00/1.00, addr 1
uhub4: 8 ports with 8 removable, self powered
viapm0 at pci0 dev 17 function 0 "VIA VT8237 ISA" rev 0x00
iic0 at viapm0
lm1 at iic0 addr 0x2f: W83782D
auvia0 at pci0 dev 17 function 5 "VIA VT8233 AC97" rev 0x60: irq 10
ac97: codec id 0x414c4760 (Avance Logic ALC655 rev 0)
audio0 at auvia0
isa0 at mainbus0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pccom2 at isa0 port 0x3e8/8 irq 5: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
biomask ff45 netmask ff45 ttymask ffc7
pctr: user-level cycle counter enabled
dkcsum: wd0 matches BIOS drive 0x80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
re2: watchdog timeout
re2: watchdog timeout
re2: watchdog timeout
re2: watchdog timeout

Reply via email to