Yesterday a bge diff has been reverted that was causing ami(4) to misbehave. This could be related and is being investigated.
On Mon, Oct 09, 2006 at 05:51:51PM -0500, [EMAIL PROTECTED] wrote: > A recent upgrade from a Sept 01 to Oct 08 snap disabled one of two NICs > on a Supermicro H8DA8/H8DAR AMD64 system. Rolling back to the Sept 1 > kernel resolved the problem. > > Specifically: > > *There are two onboard NICs, bge0 and bge1, both assigned static > addresses, and bge0 fails to operate. > > *output from ifconfig bge0 alternates automatically between > media: Ethernet autoselect (none loopback) > and > media: Ethernet autoselect > > *The lights on the NIC would alternate on and off roughly in sync with > ifconfig output (every few seconds) > > *'ifconfig bge0 down' changes the media status to active > > *'ifconfig bge0 down' (or up) takes about 15 seconds to return > > *bge1 functioned normally while bge0 was hosed > > TIA, and more information can be provided if needed. > > OpenBSD 4.0-current (GENERIC) #709: Sun Oct 8 14:48:11 MDT 2006 > [EMAIL PROTECTED]:/usr/src/sys/arch/amd64/compile/GENERIC > real mem = 1073278976 (1048124K) > avail mem = 907739136 (886464K) > using 22937 buffers containing 107536384 bytes (105016K) of memory > mainbus0 (root) > bios0 at mainbus0: SMBIOS rev. 2.3 @ 0xfc0a0 (64 entries) > bios0: Supermicro H8DA8/H8DAR > ipmi at mainbus0 not configured > cpu0 at mainbus0: (uniprocessor) > cpu0: AMD Opteron(tm) Processor 246, 1994.63 MHz > cpu0: FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36 > ,CFLUSH,MMX,FXSR,SSE,SSE2,NXE,MMXX,LONG,3DNOW2,3DNOW > cpu0: 64KB 64b/line 2-way I-cache, 64KB 64b/line 2-way D-cache, 1MB 64b/line > 16-way L2 cache > cpu0: ITLB 32 4KB entries fully associative, 8 4MB entries fully associative > cpu0: DTLB 32 4KB entries fully associative, 8 4MB entries fully associative > pci0 at mainbus0 bus 0: configuration mode 1 > ppb0 at pci0 dev 6 function 0 "AMD 8111 PCI-PCI" rev 0x07 > pci1 at ppb0 bus 4 > ohci0 at pci1 dev 0 function 0 "AMD 8111 USB" rev 0x0b: irq 9, version 1.0, l > egacy support > usb0 at ohci0: USB revision 1.0 > uhub0 at usb0 > uhub0: AMD OHCI root hub, rev 1.00/1.00, addr 1 > uhub0: 3 ports with 3 removable, self powered > ohci1 at pci1 dev 0 function 1 "AMD 8111 USB" rev 0x0b: irq 9, version 1.0, l > egacy support > usb1 at ohci1: USB revision 1.0 > uhub1 at usb1 > uhub1: AMD OHCI root hub, rev 1.00/1.00, addr 1 > uhub1: 3 ports with 3 removable, self powered > vga1 at pci1 dev 4 function 0 "ATI Rage XL" rev 0x27 > wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation) > wsdisplay0: screen 1-5 added (80x25, vt100 emulation) > pcib0 at pci0 dev 7 function 0 "AMD AMD8111 LPC" rev 0x05 > pciide0 at pci0 dev 7 function 1 "AMD 8111 IDE" rev 0x03: DMA, channel 0 conf > igured to compatibility, channel 1 configured to compatibility > pciide0: channel 0 disabled (no drives) > pciide0: channel 1 disabled (no drives) > amdiic0 at pci0 dev 7 function 2 "AMD 8111 SMBus" rev 0x02: SCI > iic0 at amdiic0 > lm1 at iic0 addr 0x2d: W83627HF > lm2 at iic0 addr 0x2f: W83792D rev D > iic0: addr 0x4a 3e=1f 4e=1f > iic0: addr 0x4c 3e=27 48=27 4e=27 fe=27 > amdpm0 at pci0 dev 7 function 3 "AMD 8111 Power" rev 0x05: rng active > iic1 at amdpm0 > ppb1 at pci0 dev 10 function 0 "AMD 8131 PCIX" rev 0x13 > pci2 at ppb1 bus 3 > bge0 at pci2 dev 5 function 0 "Broadcom BCM5704C" rev 0x10, BCM5704 B0 (0x210 > 0): irq 5, address 00:30:48:77:01:fc > brgphy0 at bge0 phy 1: BCM5704 10/100/1000baseT PHY, rev. 0 > bge1 at pci2 dev 5 function 1 "Broadcom BCM5704C" rev 0x10, BCM5704 B0 (0x210 > 0): irq 9, address 00:30:48:77:01:fd > brgphy1 at bge1 phy 1: BCM5704 10/100/1000baseT PHY, rev. 0 > "AMD 8131 PCIX IOAPIC" rev 0x01 at pci0 dev 10 function 1 not configured > ppb2 at pci0 dev 11 function 0 "AMD 8131 PCIX" rev 0x13 > pci3 at ppb2 bus 1 > ppb3 at pci3 dev 1 function 0 "Intel IOP331 PCIX-PCIX" rev 0x07 > pci4 at ppb3 bus 2 > ami0 at pci4 dev 14 function 0 "Symbios Logic MegaRAID SATA 4x/8x" rev 0x07: > irq 10 > ami0: LSI 3008, 32b, FW 813G, BIOS vH425, 128MB RAM > ami0: 1 channels, 0 FC loops, 1 logical drives > scsibus0 at ami0: 40 targets > sd0 at scsibus0 targ 0 lun 0: <AMI, Host drive #00, > SCSI2 0/direct fixed > sd0: 75340MB, 75340 cyl, 64 head, 32 sec, 512 bytes/sec, 154296320 sec total > scsibus1 at ami0: 16 targets > "AMD 8131 PCIX IOAPIC" rev 0x01 at pci0 dev 11 function 1 not configured > pchb0 at pci0 dev 24 function 0 "AMD AMD64 HyperTransport" rev 0x00 > pchb1 at pci0 dev 24 function 1 "AMD AMD64 Address Map" rev 0x00 > pchb2 at pci0 dev 24 function 2 "AMD AMD64 DRAM Cfg" rev 0x00 > pchb3 at pci0 dev 24 function 3 "AMD AMD64 Misc Cfg" rev 0x00 > isa0 at pcib0 > isadma0 at isa0 > com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo > com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo > pckbc0 at isa0 port 0x60/5 > pckbd0 at pckbc0 (kbd slot) > pckbc0: using irq 1 for kbd slot > wskbd0 at pckbd0: console keyboard, using wsdisplay0 > pcppi0 at isa0 port 0x61 > midi0 at pcppi0: <PC speaker> > spkr0 at pcppi0 > lpt0 at isa0 port 0x378/4 irq 7 > lm0 at isa0 port 0x290/8: W83627HF > lm1 detached > fdc0 at isa0 port 0x3f0/6 irq 6 drq 2 > dkcsum: sd0 matches BIOS drive 0x80 > root on sd0a > rootdev=0x400 rrootdev=0xd00 rawdev=0xd02
