I am attempting to get my Sierra Wireless AirCard 860 working properly
under OpenBSD. I have been corresponding with jolan@ regarding the issue
but we haven't been able to figure anything out. The details are as
follows:
I finally figured out the syntax of the ppp.conf file for my Cingular 3G
connection. There may still be some problems in it though:
default:
set log Phase Chat LCP IPCP CCP tun command
cingular:
set device /dev/cua03
set speed 115200
set dial "\"\" AT&F OK AT+CGDCONT=1,\\\"IP\\\",\\\"isp.cingular\\\" OK
ATD*99***1# CONNECT"
set timeout 0
set ctsrts off
enable dns
add default HISADDR
set authname "[EMAIL PROTECTED]"
set authkey "CINGULAR1"
set ifaddr 10.0.0.1/0 10.0.0.2/0 255.255.255.0 0.0.0.0
I have attempted to run this on 4.0-current from 20060930 as well as
3.9-stable with similar results on a Toshiba Libretto L1, Thinkpad X31,
and the goal of the whole project, a Soekris net4511 (and also net4521).
I have had this same problem using GENERIC on the laptops and the custom
kernel that is required for the net4511 and net4521.
I have been running ppp using: ppp -ddial cingular
The majority of the time, I get a lockup. I enabled watchdogd on the
Soekris net4521 and it would reboot the box after the specified time.
The AirCard 860 shows up on the net4521 with PCMCIADEBUG and PCCOM_DEBUG
enabled at the end of the dmesg attached below. Any ideas what could be
causing this issue? I will gladly provide any other info. Thanks.
Bryan
OpenBSD 3.9-stable (NET45xx-GPRS) #0: Thu Oct 5 18:56:38 PDT 2006
[EMAIL PROTECTED]:/export/local/src/sys/arch/i386/compile/NET45xx-GPRS
cpu0: AMD Am486DX4 W/B or Am5x86 W/B 150 ("AuthenticAMD" 486-class)
cpu0: FPU
real mem = 66691072 (65128K)
avail mem = 57356288 (56012K)
using 839 buffers containing 3436544 bytes (3356K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(00) BIOS, date 20/40/19, BIOS32 rev. 0 @ 0xf7840
pcibios0 at bios0: rev 2.0 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #2 is the last bus
bios0: ROM list: 0xc8000/0x9000
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
elansc0 at pci0 dev 0 function 0 "AMD ElanSC520 PCI" rev 0x00: product 0
stepping 1.1, CPU clock 133MHz, reset 8<WDT>
elansc0: WARNING: LAST RESET DUE TO WATCHDOG EXPIRATION!
gpio0 at elansc0: 32 pins
cbb0 at pci0 dev 17 function 0 "Texas Instruments PCI1420 CardBus" rev 0x00:
irq 10
cbb1 at pci0 dev 17 function 1 "Texas Instruments PCI1420 CardBus" rev 0x00:
irq 10
sis0 at pci0 dev 18 function 0 "NS DP83815 10/100" rev 0x00, DP83816A: irq 11,
address 00:00:24:c3:07:d4
nsphyter0 at sis0 phy 0: DP83815 10/100 PHY, rev. 1
sis1 at pci0 dev 19 function 0 "NS DP83815 10/100" rev 0x00, DP83816A: irq 5,
address 00:00:24:c3:07:d5
nsphyter1 at sis1 phy 0: DP83815 10/100 PHY, rev. 1
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 1 device 0 cacheline 0x10, lattimer 0x3f
pcmcia0 at cardslot0
cardslot1 at cbb1 slot 1 flags 0
cardbus1 at cardslot1: bus 2 device 0 cacheline 0x10, lattimer 0x3f
pcmcia1 at cardslot1
isa0 at mainbus0
isadma0 at isa0
wdc0 at isa0 port 0x1f0/8 irq 14
wd0 at wdc0 channel 0 drive 0: <SanDisk SDCFB-512>
wd0: 1-sector PIO, LBA, 488MB, 1000944 sectors
wd0(wdc0:0:0): using BIOS timings
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
biomask f7c7 netmask ffe7 ttymask ffe7
wi0 at pcmcia0 function 0 "INTERSIL, HFA384x/IEEE, Version 01.02"pcmcia0:
++enabled_count = 1
pcmcia0: function 0 CCR at 0 offset 3e0: 41 80 22 ff, ff ff ff ff, ff
port 0xa000/64
wi0: PRISM2.5 ISL3873 (0x800c), Firmware 1.1.1 (primary), 1.7.4 (station),
address 00:02:6f:04:78:dd
pcmcia0: function 0 CCR at 0 offset 3e0: 41 80 22 ff, ff ff ff ff, ff
?V card, 0x30000116
dkcsum: wd0 matches BIOS drive 0x80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
WARNING: clock time much less than file system time
WARNING: using file system time
WARNING: CHECK AND RESET THE DATE!
pccom2 at pcmcia1 function 1 "Sierra Wireless, AC860, 3G Network
Adapter"pcmcia1: ++enabled_count = 1
pcmcia1: function 1 CCR at 0 offset 700: 60 20 0 0, 0 0 0 0, 0
port 0xa3f8/8: ns16550a, 16 byte fifo
pcmcia1: function 1 CCR at 0 offset 700: 60 20 0 0, 0 0 0 0, 0
