I did a dmesg trying to use a bluetooth adaptor to connect to the mobile
phone and use it as a modem, which I can't fully post here as the OBSD3.8
is installed in a laptop without internet access but I copied by hand the
lines relating to the bluetooth adaptor and this is what is says on the
lines where Bluetooth is named:
"
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
ugen0 at uhub1 port 1
ugen0: Broadcom Belkin Bluetooth Device, rev 1.10/0.01 , addr2
syncing disks...
"
then it gets named on another line:
"
ugen0: Broadcom Belkin Bluetooth Device, rev 1.10/0.01, addr 2
dkcsum:wd0 matches BIOS drive 0x80
root on wd0a
"
I hope this information is enough to understand how it works, I have seen
"not configured" anywhere it looks to me like the device is recognised by
OBSD3.8, if I am right I would appreciate some help configuring this so
that I can use the mobile phone to dial up and connect to the net, if I
manage I will send the full dmseg to the list.
In the ppp.conf file I have the cua0 as a dev I do not know if this is the
right one as that was meant to be for a modem.
Zoraya
--
Using Opera's revolutionary e-mail client: http://www.opera.com/mail/
