Some progress. Thank you. Still stuck though. Post network configuration, The boot installer asks for HTTP Server? (hostname or 'done'). hostname. Server Directory? [pub/OpenBSD/7.0/arm64].
It fails at this step: Unable to connect using https. Use http instead. Looked at found no OpenBSD/arm64 7.0 sets. I tried with pub/OpenBSD/snapshots/arm64. That didn't work either. On Thu, Sep 30, 2021 at 11:48 AM Stuart Henderson <s...@spacehopper.org> wrote: > > Change the server directory to /pub/OpenBSD/snapshots/arm64. We're in the > awkward time where the version number is just 7.0 so the installer thinks it > is a released version, but the release hasn't been made yet, and there is no > mechanism for the installer to fetch that information online, so you have to > do it manually. > > -- > Sent from a phone, apologies for poor formatting. > > > On 30 September 2021 03:18:36 Sandeep Gupta <gupta.sand...@gmail.com> wrote: >> >> This is my second attempt to install openBSD on RPI4. I write out the UEFI >> to sdcard and miniroot.img to usb-ssd drive which takes some 16MB of space. >> The rest I create a new fat32 partition. This works -- the boot loader kicks >> off the openBSD installer. >> The installer after asking for disk partitions, reaches till installing >> sets.However, >> it doesn't give me option to install bsd or bsd.rd (see attached pic below). >> >> Not sure if I am messing up the disk partition where openbsd should be >> installed. I tried both sd1 and sd1a. But both end up having the same issue. >> >> -S >> >> On Wednesday, September 29, 2021, Stuart Henderson >> <stu.li...@spacehopper.org> wrote: >> > >> > On 2021-09-28, Peter J. Philipp <p...@delphinusdns.org> wrote: >> > > On Tue, Sep 28, 2021 at 10:04:25AM -0700, Joseph Olatt wrote: >> > >> I tried the following snapshot: >> > >> >> > >> https://cdn.openbsd.org/pub/OpenBSD/snapshots/arm64/miniroot70.img >> > >> >> > >> Build date: 27-Sep-2021 20:10 >> > >> Size: 45088768 >> > >> >> > >> Didn't have much luck. The install process rebooted after the following >> > >> error: >> > >> >> > >> bwfm0: failed loadfirmware of file >> > >> brcmfmac43455-sdio.raspberrypi,4-model-b.bin >> > >> panic: do_el0_error >> > > >> > > What happens when you boot with -c and 'disable bwfm' then exit? Is >> > > that not >> > > an option anymore? >> > >> > I am pretty sure the do_el0_error is unrelated to the loadfirmware() >> > failing >> > (which is just because the firmware for the device isn't installed yet). >> > >> > > >
