Ok, done. I have already sent the bug report.
On 21/10/2020, 11:11, "Uwe Werler" <u...@werler.is> wrote:
On 21 Oct 07:12, Carlos Lopez wrote:
> Hi all,
>
> Before upgrade from OpenBSD 6.7 to OpenBSD 6.8, my pair firewalls was
using carp in IP balance mode without problems from several months. These
firewalls are installed in a RHEL 8.2 (fully patched) KVM host.
>
> After upgrading to OpenBSD 6.8, carp ip balance mode doesn’t works. I
have tested reconfiguring balance mode for ip-stealth and ip-unicast also and
the result is always the same: network packets are not processed by firewalls.
But if I configure CARP using “the simple configuration” and one node is master
and the other is backup all it is working without problems.
>
> Since the configuration is exactly the same for version 6.8 as it was for
version 6.7, could there be some kind of problem with the virtio driver on the
network interfaces in version 6.8?
>
> Regards,
> C. L. Martinez
Hi folks,
I run into exactly the same issue with my ldap proxy. When one node is
master
for both carp nodes it responds to packets addressed to the carp ip. In load
balancing mode it sometimes responds depending on the source ip.
Please open a bug report.
--
wq: ~uw
