On 2018-04-13, Edmund Craske <edm...@m00is.net> wrote: > Hi, > I've just replaced my old OpenBSD 5.x-running router with a new one (Alix > APU2) running 6.3. > > Having copied over my old configuration and modified it where necessary, I've > got it bringing up my connections fine, IPv4 works, but IPv6 does not, > without having to manually add a default route after the connection is up. > > I already tripped over (and fixed) the fact that you have to put %<interface> > on the end of your inet6 route destinations now, but even having done that, > for some reason a default route does not get added correctly on boot with the > following line present in my /etc/hostname.pppoe0: > > !/sbin/route add -inet6 default -ifp pppoe0 fe80::%pppoe0 > > Looking at the console output on boot it doesn't show any error running that > command (implying that the route should have been added just fine) but it's > definitely not there any more when doing a 'netstat -rn' once the ppp session > is established - is something removing it as part of establishing the > connection? > > Is there a completely different way that I should be doing this than the one > shown in the pppoe(4) man page? I have already tried having 'inet6 autoconf' > instead of 'inet6 eui64' but for some reason I don't get a SLAAC > configuration and IPv6 doesn't come up that way. I don't know if anything has > to be explicitly enabled to make SLAAC work or if I am inadvertently blocking > something that I need to allow in my pf ruleset? > > I am in the UK, using a Draytek Vigor 130 VDSL modem with FTTC to Andrews & > Arnold (AAISP). > > Thanks in advance for any help :) > > Edmund > >
Can you show your whole hostname.pppoe0 file? (mask your password of course). On Zen I'm using the following mtu 1500 inet 0.0.0.0 255.255.255.255 0.0.0.1 pppoedev em1 authproto chap authname "XXX@zen" authkey "XXX" up inet6 -autoconfprivacy inet6 autoconf !/sbin/route add default -ifp pppoe0 0.0.0.1 !/sbin/route add -inet6 default -ifp pppoe0 fe80::%pppoe0 -priority 8 and hostname.em1 has mtu 1508 up In my case, I'm using dhcpcd from packages to get addresses for my internal networks, Zen don't statically route my v6 block unless I request it via DHCPv6-PD, but you won't need that with A&A, you can just configure them statically on the inside interfaces.
