Hi Antoine, I can confirm that the Plugin installation works now for me:
cd plugin_tmp/ /local/bin/python2.7 plugin_install.py Do you accept the license terms for the plug-in (y=yes*, n=no, q=quit) ? y sh: lsb_release: not found Done. But I still cant get the printer to work! The good news it that scanning works now, but if I try to print I get an error about the missing plugin. So here is what I did: - Installing hplip / hplip-gui and gtk+2-cups / gtk+3-cups - doing the plugin installation shown above When I try to print a testpage hplip-systray says: required plugin not found! I did copy HP_LaserJet_MFP_M129-M134.ppd from /etc/cups/ppd/ to /usr/local/share/foomatic/db/source/PPD/HP/ (cause the gui setup is looking there), but no effect! What am I missing? Thx Claus 15.06.2017, 09:41, "Antoine Jacoutot" <ajacou...@bsdfrog.org>: > On Sun, Jun 04, 2017 at 07:09:19PM +0200, Reheis Claus wrote: >> Hi all, >> >> Recently I acquired an HP Laserjet Pro MFP M130fn and I would like to >> use it with my OpenBSD Deskop... >> As it is supported since hplip 3.17 I have to use OpenBSD Current. >> I managed to get until the plugin installation, but now I am stuck at >> the point: >> >> /usr/local/bin/python2.7 plugin_install.py >> >> License blablabla >> >> Do you accept the license terms for the plug-in (y=yes*, n=no, q=quit) ? y >> sh: lsb_release: not found >> Plugin installation failed >> error: Plugin installation failed >> >> Any advice? thx > > Hi. > > Thanks for the report. > FWIW I just fixed it in current. > > -- > Antoine
