Thanks,I was mostly checking if this was a known issue.If I rename
hostname.pppoe0 to hostname.pppoe1 and then rename hostname.pppoe2 to
hostname.pppoe0The original pppoe2 (now pppoe0) works fine but the other
interface stops working. If I swap them back the original behaviour is seen.
ifconfig pppoe2 debug shows no ouput.As shown below pppoe2 just stays in
state: initial.
vr2: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:00:24:d1:9d:6a
priority: 0
media: Ethernet autoselect (100baseTX full-duplex)
status: active
pppoe2: flags=8810<POINTOPOINT,SIMPLEX,MULTICAST> mtu 1492
priority: 0
dev: vr2 state: initial
sid: 0x0 PADI retries: 0 PADR retries: 0
groups: pppoe
status: no carrier
I have now "upgraded" to 6.1. The same is noted
Any thoughts would be appreciated.
On Wednesday, 10 May 2017, 19:16, Gregory Edigarov <ediga...@qarea.com>
wrote:
Hi,
before anything it is necessary to provide a defintion of "not working"
and some evidence, like ifconfig, netstat -rn, ping, etc. then somebody
will be able to help you.
the more information you will provide, the quicker response with a
solution you will get.
On 10.05.17 07:53, Steve wrote:
> Hello,
> In 5.7 it was possible to have multiple pppoe interfaces active and
> working.This used to work fine with ifstated monitoring for outage and
> changing routing appropriatelyIn either 5.8 or 5.9 this seems to have stopped
> working.With both interfaces configured only one interface will ever become
> active.
> I am unable to test with 6.0 or 6.1 at the moment.
> Is anyone familiar with this issue ?
> Can anyone confirm if this is resolved in 6.0 or 6.1.
> Thank you.
