On Thu, Oct 13, 2016 at 05:16:05PM +0200, Reyk Floeter wrote: > > Am 13.10.2016 um 16:18 schrieb Dimitris Papastamos <s...@2f30.org>: > > > >> On Thu, Oct 13, 2016 at 03:43:54PM +0200, Stefan Sperling wrote: > >>> On Thu, Oct 13, 2016 at 02:23:20PM +0100, Edd Barrett wrote: > >>> Hi, > >>> > >>> Since vmm is now enabled, I thought I would have a play. > >>> > >>> So far so good, but I've not managed to get the host on the internet > >>> yet. > >>> > >>> If I set up a vmm VM on my laptop, we have on the host: > >>> > >>> * iwn0 providing internet access to the host > >>> * tap0 connected to vio0 in the guest. > >>> > >>> What is the reccommended way to give the guest internet access via iwn0? > >>> > >>> I thought I could bridge the interfaces using bridge(4), but it seems I > >>> am wrong. (I have a vague recollection that a bridge involving a > >>> wireless interface doesn't do as one might expect, but I don't recall > >>> the exact details). > >>> > >>> (I also tried routing between the two interfaces, using static addresses > >>> for tap0 and vio0, then adding a default route in the guest and a static > >>> route in the host. I was able to ping between the host and guest via > >>> tap, but I couldn't ping between subnets.) > >>> > >>> (Yep, I have net.inet.ip.forwarding=1). > >> > >> Use NAT. > >> > >> Bridging over wifi does not work (limitation of the ieee802.11 standard). > > > > Just hijacking the thread for a moment, I tried vmm yesterday in > > bridge mode with em(4). Everything works fine except dhcp. I cannot use > > dhclient to get an address from within the vm. IPv6 SLAAC works though > > as well as setting IPv4 addresses manually. > > > > Any ideas? > > > > Do you run dhclient on the host as well (on em0)?
Yes I do. > It is a known problem that dhclient "steals" dhcp packets from the stack with > its bpf drop filter. > > For laptop or mobile hosts, I suggest to use NAT and dhcpd on a vether0 in the > same bridge as the taps. Thanks, will try that!
