On 06/12/2012 06:38 PM, Peter N. M. Hansteen wrote:
Myles Merrell<gutter...@yahoo.com> writes:
Recently, we noticed all of our network traffic inside the
firewall slowed down to the point where it was difficult to access anything.
After some nosing around we noticed that f2, the em2 interface which is using
CARP pfsync, was causing an extremely large amounts of errors, essentially
choking out the rest of the network traffic.
possibly dumb question but better eliminate the obvious: you did set up
a separate network for the pfsync traffic?
my next thought is that large numbers of errors on a specific interface
tends to point to a hardware problem, either the card itself, the cables
involved or the switch port.
- P
Hi,
I'm using OpenBSD 5.1 on 2 Dell R210 (with em interfaces) and i ran into
the same problem two weeks ago.
We tried to upgrade all the firmware cards with the Dell utility (F10 in
Bios) and for the moment, the problem has gone away (but we're not sure
this is not a coincidence).
--
Mathieu
