Hi Everyone,
I've been googling and reading but haven't been able to find anything that
might help me solve a problem. Hoping you might be able to help. I haven't
done anything with a ux system in years and forgot most of what I knew.
I purchased an ALIX2 with 3 network ports to use as a firewall. I installed
the latest build of flashrd onto the compact flash. I'm connected to the
Alix using putty and a serial port. I have to manually set the console
during boot, until I'm able to get it to boot to the point where I can upate
the /etc/boot.conf. I have no other ux boxes so have to do everything on
the Alix.
It seems to boot fine but when it posts the system date/time it hangs. I
can't type anything. Any ideas?
Thank you,
Dave
PC Engines ALIX.2 v0.99h
640 KB Base Memory
261120 KB Extended Memory
01F0 Master 848A SanDisk SDCFH-002G
Phys C/H/S 3875/16/63 Log C/H/S 968/64/63
Using drive 0, partition 3.
Loading......
probing: pc0 com0 com1 pci mem[640K 255M a20=on]
disk: hd0+
>> OpenBSD/i386 BOOT 3.16
boot> stty com0 38400
boot> set tty com0
switching console to com0
rzA9 M=%MaY ==QM9EY)5==Qy
booting hd0a:/bsd: 11954772+518192 [61+363872+349873]=0xc93874
entry point at 0x200120
[ using 714224 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2011 OpenBSD. All rights reserved.
http://www.OpenBSD.org
OpenBSD 4.9-current (FLASHRD) #4: Sat Apr 23 19:36:54 MDT 2011
r...@mina.nmedia.net:/usr/src/sys/arch/i386/compile/FLASHRD
cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class)
499 MHz
cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX
real mem = 268009472 (255MB)
avail mem = 250441728 (238MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 11/05/08, BIOS32 rev. 0 @ 0xfd088
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xe0000/0xa800
cpu0 at mainbus0: (uniprocessor)
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33
glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10,
address 00:0d:b9:25:ee:7c
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11,
address 00:0d:b9:25:ee:7d
ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
vr2 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 15,
address 00:0d:b9:25:ee:7e
ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 3, 32-bit
3579545Hz timer, watchdog, gpio
gpio0 at glxpcib0: 32 pins
pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0
wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <SanDisk SDCFH-002G>
wd0: 1-sector PIO, LBA, 1907MB, 3906560 sectors
wd0(pciide0:0:0): using PIO mode 4, DMA mode 2
pciide0: channel 1 ignored (disabled)
ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 12, version
1.0, legacy support
ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 12
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1
isa0 at glxpcib0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: console
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
cannot support dma lance devices
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
usb1 at ohci0: USB revision 1.0
uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1
biomask 73e7 netmask ffe7 ttymask ffff
mtrr: K6-family MTRR support (2 registers)
nvram: invalid checksum
rd0: fixed, 7480 blocks
vscsi0 at root
scsibus0 at vscsi0: 256 targets
softraid0 at root
root on rd0a swap on rd0b dump on rd0b
clock: unknown CMOS layout
WARNING: clock time much less than file system time
WARNING: using file system time
WARNING: CHECK AND RESET THE DATE!
/dev/rwd0a: 8 files, 485306 used, 457909 free (21 frags, 57236 blocks, 0.0%
fragmentation)
/dev/rwd0a: MARKING FILE SYSTEM CLEAN
/dev/rvnd0a: file system is clean; not checking
/dev/rvnd0d: file system is clean; not checking
/dev/rvnd0e: file system is clean; not checking
/dev/rvnd0f: file system is clean; not checking
/dev/rvnd0g: file system is clean; not checking
Automatic boot in progress: starting file system checks.
setting tty flags
pf enabled
starting network
tardirs: extracting var
starting system logger
starting initial daemons:.
savecore: can't find device 17/1
checking quotas: done.
building ps databases: kvm dev.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files.
starting network daemons: sshd sendmail inetd.
starting local daemons:.
flashrd: moving mounts to read-only mode
starting standard daemons: cron.
Sat Apr 23 19:13:29 MDT 2011
