Hello misc,
I have problem mounting usb disk at boot time (namely Western Digital My
Book 1130) on Alix2d2 board, dmesg below.
I am getting this message and the disk is not mounted:
mount_ffs: /dev/sd0a on /data: Device not configured
also:
r...@asterisk1.my.domain
~ # mount
/dev/wd0a on / type ffs (local)
/dev/wd0e on /home type ffs (local, nodev, nosuid)
/dev/wd0d on /mfs type ffs (local, nodev, nosuid)
After boot, I can mount it "by hand" without problem issuing:
r...@asterisk1.my.domain
~ # mount /dev/sd0a /data
and:
r...@asterisk1.my.domain
~ # mount
/dev/wd0a on / type ffs (local)
/dev/wd0e on /home type ffs (local, nodev, nosuid)
/dev/wd0d on /mfs type ffs (local, nodev, nosuid)
/dev/sd0a on /data type ffs (local)
My fstab is:
/dev/wd0a / ffs rw 1 1
/dev/wd0e /home ffs rw,nodev,nosuid 1 2
/dev/wd0d /mfs ffs rw,nodev,nosuid 1 2
/dev/sd0a /data ffs rw,nodev 0 0
How can I mount this disk at boot?
Thanks for the help,
Ivo
Dmesg:
OpenBSD 4.8-stable (GENERIC) #1: Wed Apr 6 17:51:44 EEST 2011
r...@mail.bgone.bg:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD"
586-class) 499 MHz
cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX
real mem = 268009472 (255MB)
avail mem = 253669376 (241MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 11/05/08, BIOS32 rev. 0 @ 0xfd088
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xe0000/0xa800
cpu0 at mainbus0: (uniprocessor)
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33
glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10,
address 00:0d:b9:20:95:08
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
vr1 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 15,
address 00:0d:b9:20:95:09
ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x004063, model 0x0034
glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 3,
32-bit 3579545Hz timer, watchdog, gpio
gpio0 at glxpcib0: 32 pins
pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <TS4GCF133>
wd0: 1-sector PIO, LBA, 3823MB, 7831152 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 ignored (disabled)
ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 12,
version 1.0, legacy support
ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 12
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1
isa0 at glxpcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: console
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
usb1 at ohci0: USB revision 1.0
uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1
biomask 7be7 netmask ffe7 ttymask ffff
mtrr: K6-family MTRR support (2 registers)
nvram: invalid checksum
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
clock: unknown CMOS layout
umass0 at uhub0 port 2 configuration 1 interface 0 "Western Digital My
Book 1130" rev 2.10/10.12 addr 2
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets, initiator 0
Automatic boot in progress: starting file system checks.
/dev/rwd0a: file system is clean; not checking
/dev/rwd0e: file system is clean; not checking
/dev/rwd0d: file system is clean; not checking
mount_ffs: /dev/sd0a on /data: Device not configured
setting tty flags
pf enabled
net.inet.ip.forwarding: 0 -> 1
starting network
DHCPREQUEST on vr0 to 255.255.255.255 port 67
DHCPACK from 192.168.75.1 (00:1e:58:9f:a5:ff)
bound to 192.168.75.66 -- renewal in 21600 seconds.
starting system logger
starting initial daemons: ntpd.
mount_ffs: /dev/sd0a on /data: Device not configured
savecore: no core dump
checking quotas: done.
building ps databases: kvm dev.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
sd0 at scsibus0 targ 1 lun 0: <WD, My Book 1130, 1012> SCSI4 0/direct fixed
sd0: 953837MB, 512 bytes/sec, 1953458176 sec total
ses0 at scsibus0 targ 1 lun 1: <WD, SES Device, 1012> SCSI4 13/enclosure
services fixed
ses0: unable to read enclosure configuration
creating runtime link editor directory cache.
preserving editor files.
starting network daemons: sshd sendmail inetd.
starting local daemons:.
standard daemons: cron.
Mon May 2 09:36:28 EEST 2011
OpenBSD/i386 (asterisk1.my.domain) (tty00)
