Hi all,
I know this setup might not be fully supported but I wanted to report this.
On my Sun Fire V240 I have two softraid(4) volumes:
- sd4 (UUID a45b5629cc97897e), RAID1 for : /tmp, /var, /usr, /home
- sd5 (UUID 5cd55a71b5790766), RAID0 for data.
My /etc/fstab is as follows:
00000000438d5c40.b none swap sw 0 0
/dev/sd0a / ffs rw,softdep 1 1
00000000438d5c40.a /altroot ffs xx 0 0
a45b5629cc97897e.h /home ffs rw,nodev,nosuid,softdep 1 2
a45b5629cc97897e.d /tmp ffs rw,nodev,nosuid,softdep 1 2
a45b5629cc97897e.g /usr ffs rw,nodev,softdep 1 2
a45b5629cc97897e.e /var ffs rw,nodev,nosuid,softdep 1 2
5cd55a71b5790766.k /var/www/ftp ffs rw,nodev,nosuid,softdep 1 2
When I try to reboot the machine, it stalls at:
$ sudo reboot
/etc/rc.shutdown in progress...
stopping local daemons: mysqld.
/etc/rc.shutdown complete.
syncing disks... done
sd5 detached
scsibus5 detached
sd4 detached
scsibus4 detached
The only way to reboot the machine is via ALOM.
Here is a dmesg:
Rebooting with command: boot
Boot device: disk0 File and args:
OpenBSD IEEE 1275 Bootblock 1.3
..>> OpenBSD BOOT 1.4
Trying bsd...
Booting /pci@1c,600000/scsi@2/disk@0,0:a/bsd
6557872@0x1000000+3920@0x16410b0+179568@0x1800000+4014736@0x182bd70
symbols @ 0xfecd2300 90+403728+254301 start=0x1000000
[ using 658896 bytes of bsd ELF symbol table ]
console is /pci@1e,600000/isa@7/serial@0,3f8
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2011 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 4.9 (GENERIC.MP) #2: Wed Mar 2 13:13:28 CET 2011
r...@test.brimbelle.org:/usr/src/sys/arch/sparc64/compile/GENERIC.MP
real mem = 2147483648 (2048MB)
avail mem = 2101043200 (2003MB)
mainbus0 at root: Sun Fire V240
cpu0 at mainbus0: SUNW,UltraSPARC-IIIi (rev 2.4) @ 1280 MHz
cpu0: physical 32K instruction (32 b/l), 64K data (32 b/l), 1024K
external (64 b/l)
cpu1 at mainbus0: SUNW,UltraSPARC-IIIi (rev 2.4) @ 1280 MHz
cpu1: physical 32K instruction (32 b/l), 64K data (32 b/l), 1024K
external (64 b/l)
"memory-controller" at mainbus0 not configured
"memory-controller" at mainbus0 not configured
schizo0 at mainbus0: "Tomatillo", version 4, ign 7c0, bus B 0 to 0
schizo0: dvma map c0000000-dfffffff
pci0 at schizo0
bge0 at pci0 dev 2 function 0 "Broadcom BCM5704C" rev 0x00, BCM5704 A3
(0x2003): ivec 0x7c8, address 00:03:ba:bd:ee:a1
brgphy0 at bge0 phy 1: BCM5704 10/100/1000baseT PHY, rev. 0
bge1 at pci0 dev 2 function 1 "Broadcom BCM5704C" rev 0x00, BCM5704 A3
(0x2003): ivec 0x7c9, address 00:03:ba:bd:ee:a2
brgphy1 at bge1 phy 1: BCM5704 10/100/1000baseT PHY, rev. 0
schizo1 at mainbus0: "Tomatillo", version 4, ign 780, bus A 0 to 0
schizo1: dvma map c0000000-dfffffff
pci1 at schizo1
ebus0 at pci1 dev 7 function 0 "Acer Labs M1533 ISA" rev 0x00
"flashprom" at ebus0 addr 0-fffff, 290-290 not configured
rtc0 at ebus0 addr 70-71: m5819p
pcfiic0 at ebus0 addr 320-321 ivec 0x2e
iic0 at pcfiic0
"SUNW,i2c-imax" at iic0 addr 0xb not configured
"SUNW,i2c-imax" at iic0 addr 0xc not configured
spdmem0 at iic0 addr 0x5b: 512MB DDR SDRAM registered ECC PC2300CL2.5
spdmem1 at iic0 addr 0x5c: 512MB DDR SDRAM registered ECC PC2300CL2.5
spdmem2 at iic0 addr 0x63: 512MB DDR SDRAM registered ECC PC2300CL2.5
spdmem3 at iic0 addr 0x64: 512MB DDR SDRAM registered ECC PC2300CL2.5
"ds1307" at iic0 addr 0x68 not configured
"pca9555" at iic0 addr 0x22 not configured
"pca9555" at iic0 addr 0x23 not configured
"pca9555" at iic0 addr 0x25 not configured
"pca9555" at iic0 addr 0x44 not configured
"pca9556" at iic0 addr 0x38 not configured
power0 at ebus0 addr 800-82f ivec 0x20
com0 at ebus0 addr 3f8-3ff ivec 0x2c: ns16550a, 16 byte fifo
com0: console
com1 at ebus0 addr 2e8-2ef ivec 0x2c: ns16550a, 16 byte fifo
"rmc-comm" at ebus0 addr 3e8-3ef ivec 0x2c not configured
alipm0 at pci1 dev 6 function 0 "Acer Labs M7101 Power" rev 0x00: 223KHz clock
iic1 at alipm0
ohci0 at pci1 dev 10 function 0 "Acer Labs M5237 USB" rev 0x03: ivec
0x7a7, version 1.0, legacy support
pciide0 at pci1 dev 13 function 0 "Acer Labs M5229 UDMA IDE" rev 0xc4:
DMA, channel 0 configured to native-PCI, channel 1 configured to
native-PCI
pciide0: using ivec 0x798 for native-PCI interrupt
atapiscsi0 at pciide0 channel 0 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <TEAC, DV-28E-C, 1.4B> ATAPI 5/cdrom removable
cd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 disabled (no drives)
usb0 at ohci0: USB revision 1.0
uhub0 at usb0 "Acer Labs OHCI root hub" rev 1.00/1.00 addr 1
schizo2 at mainbus0: "Tomatillo", version 4, ign 700, bus A 0 to 0
schizo2: dvma map c0000000-dfffffff
pci2 at schizo2
siop0 at pci2 dev 2 function 0 "Symbios Logic 53c1010-66" rev 0x01:
ivec 0x729, using 8K of on-board RAM
scsibus1 at siop0: 16 targets, initiator 7
sd0 at scsibus1 targ 0 lun 0: <SEAGATE, ST336607LSUN36G, 0207> SCSI3
0/direct fixed
sd0: 34732MB, 512 bytes/sec, 71132959 sec total
sd1 at scsibus1 targ 1 lun 0: <SEAGATE, ST336607LSUN36G, 0207> SCSI3
0/direct fixed
sd1: 34732MB, 512 bytes/sec, 71132959 sec total
sd2 at scsibus1 targ 2 lun 0: <COMPAQ, BF1468A4B3, HPB5> SCSI3 0/direct fixed
sd2: 140014MB, 512 bytes/sec, 286749488 sec total
sd3 at scsibus1 targ 3 lun 0: <COMPAQ, BF14687B56, HPB9> SCSI3 0/direct fixed
sd3: 140014MB, 512 bytes/sec, 286749488 sec total
siop1 at pci2 dev 2 function 1 "Symbios Logic 53c1010-66" rev 0x01:
ivec 0x728, using 8K of on-board RAM
scsibus2 at siop1: 16 targets, initiator 7
schizo3 at mainbus0: "Tomatillo", version 4, ign 740, bus B 0 to 0
schizo3: dvma map c0000000-dfffffff
pci3 at schizo3
bge2 at pci3 dev 2 function 0 "Broadcom BCM5704C" rev 0x00, BCM5704 A3
(0x2003): ivec 0x75c, address 00:03:ba:bd:ee:a3
brgphy2 at bge2 phy 1: BCM5704 10/100/1000baseT PHY, rev. 0
bge3 at pci3 dev 2 function 1 "Broadcom BCM5704C" rev 0x00, BCM5704 A3
(0x2003): ivec 0x75d, address 00:03:ba:bd:ee:a4
brgphy3 at bge3 phy 1: BCM5704 10/100/1000baseT PHY, rev. 0
ifb0 at pci3 dev 1 function 0 "3D Labs Wildcat 5110" rev 0x01
ifb0: XVR-500 (SUNW,375-3069), 1152x900
wsdisplay0 at ifb0 mux 1
wsdisplay0: screen 0 added (std, sun emulation)
siop0: target 0 now using tagged DT 16 bit 80.0 MHz 62 REQ/ACK offset xfers
vscsi0 at root
scsibus3 at vscsi0: 256 targets
softraid0 at root
siop0: target 1 now using tagged DT 16 bit 80.0 MHz 62 REQ/ACK offset xfers
siop0: target 2 now using tagged DT 16 bit 80.0 MHz 31 REQ/ACK offset xfers
siop0: target 3 now using tagged DT 16 bit 80.0 MHz 31 REQ/ACK offset xfers
scsibus4 at softraid0: 1 targets
sd4 at scsibus4 targ 0 lun 0: <OPENBSD, SR RAID 1, 004> SCSI2 0/direct fixed
sd4: 32433MB, 512 bytes/sec, 66423360 sec total
scsibus5 at softraid0: 1 targets
sd5 at scsibus5 targ 0 lun 0: <OPENBSD, SR RAID 0, 004> SCSI2 0/direct fixed
sd5: 280023MB, 512 bytes/sec, 573487616 sec total
bootpath: /pci@1c,600000/scsi@2,0/disk@0,0
root on sd0a swap on sd0b dump on sd0b
swapctl: adding 00000000438d5c40.b as swap device at priority 0
Automatic boot in progress: starting file system checks.
/dev/rsd0a: file system is clean; not checking
/dev/sd5k (5cd55a71b5790766.k): file system is clean; not checking
/dev/sd4h (a45b5629cc97897e.h): file system is clean; not checking
/dev/sd4d (a45b5629cc97897e.d): file system is clean; not checking
/dev/sd4g (a45b5629cc97897e.g): file system is clean; not checking
/dev/sd4e (a45b5629cc97897e.e): file system is clean; not checking
setting tty flags
pf enabled
starting network
starting system logger
starting named
starting initial daemons: ntpd.
savecore: no core dump
checking quotas: done.
building ps databases: kvm dev.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files.
starting network daemons: sshd sendmail httpd ftpd inetd.
starting local daemons: mysqld.
standard daemons: cron.
Tue Mar 8 10:58:39 CET 2011
OpenBSD/sparc64 (test.brimbelle.org) (console)
login:
--
Mattieu Baptiste
"/earth is 102% full ... please delete anyone you can."
