On Mon, Aug 08, 2005 at 10:05:50PM -0400, Nick Holland wrote:
> James Boothe wrote:
> > I'm having a bit of trouble with ccd. I have a box with 2 80G IDE
> > drives and 1 200G IDE drive. I'm going by the FAQ step for step
> > here but after the ccd is configured and I get ready to run
> > disklabel -E ccd0 it only sees the first frive. I've redone it 6 or
> > 7 times, and switched the drive order in ccd.conf. I've tried
> > taking each drive out one at a time and doing it with the other two
> > drives but it always ends up the same. I'm hoping somebody can
> > help me out here. Hre's what I have in ccd.conf
> >
> > ccd0 16 none /dev/wd2a /dev/wd1a /dev/wd0h
> >
> > wd2a is the 200G drive with one big empty partition
> > wd1a is one of the 80G drives with one big empty partition
> > wd0h is 78G, the other 2 went to the OS
> >
> > Any help or ideas would be appreciated. If there is any relevent
> > information I left out let me know.
>
> Show us what you are seeing and tell us what you are expecting to see.
> Yes, "disklabel -E ccd0" should only show you one "drive", so I have no
> idea what you are not seeing that you are expecting.
>
> ("trivial" little things like dmesg, disklabel and fdisk outputs might
> be useful, too).
>
> Nick.
Thanks for the reply. I got it working finally though. Yes I realize
it will show up as one disk in disklabel, that's pretty much the point
of ccd. The problem was it was only showing the first disk as in 80G,
not 200+80+80GB. I'm still not sure what the exact problem was but
about 8 tries and several reboots and obscenities later it magically
started working.
