Hello people
I've recently baught myself one of these small little WRAP boards (http://www.pcengines.ch/wrap.htm), soekris-look-alike. After installing -current on it, I noticed the following:
------ # dhclient sis0 DHCPDISCOVER on sis0 to 255.255.255.255 port 67 interval 6 ip length 328 disagrees with bytes received 332. accepting packet with data after udp payload. DHCPOFFER from 10.0.0.1
DHCPREQUEST on sis0 to 255.255.255.255 port 67 ip length 328 disagrees with bytes received 332. accepting packet with data after udp payload. DHCPACK from 10.0.0.1 bound to 10.0.0.23 -- renewal in 10800 seconds. ------
Looking though the archives I found these posts:
http://marc.theaimsgroup.com/?l=openbsd-misc&m=106059883119865 http://marc.theaimsgroup.com/?l=openbsd-tech&m=105760910331290
The patch in the last post seems to have been applied already. I remember that nsphyter was added recently, could that have anything to do with this?
Everything works, I just reacted on the "disagrees with bytes" part. IPv6 via rtsol works aswell, as I saw that Paul de Weerd in the last post had problems with that. Just wanted to inform you, in case this is a driver bug.
Full dmesg below.
/Johan
OpenBSD 3.7-current (GENERIC) #110: Mon May 2 20:07:58 MDT 2005
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
RTC BIOS diagnostic error 80<clock_battery>
cpu0: Geode(TM) Integrated Processor by National Semi ("Geode by NSC"
586-class) 267 MHz
cpu0: FPU,TSC,MSR,CX8,CMOV,MMX
cpu0: TSC disabled
real mem = 133804032 (130668K)
avail mem = 115552256 (112844K)
using 1658 buffers containing 6791168 bytes (6632K) of memory
RTC BIOS diagnostic error 80<clock_battery>
mainbus0 (root)
bios0 at mainbus0: AT/286+(ac) BIOS, date 07/13/04, BIOS32 rev. 0 @ 0xfc554
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Cyrix GXm PCI" rev 0x00
sis0 at pci0 dev 14 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, irq 10,
address 00:0d:b9:01:20:04
nsphyter0 at sis0 phy 0: DP83815 10/100 PHY, rev. 1
sis1 at pci0 dev 15 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, irq 9,
address 00:0d:b9:01:20:05
nsphyter1 at sis1 phy 0: DP83815 10/100 PHY, rev. 1
sis2 at pci0 dev 16 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, irq 11,
address 00:0d:b9:01:20:06
nsphyter2 at sis2 phy 0: DP83815 10/100 PHY, rev. 1
gscpcib0 at pci0 dev 18 function 0 "NS SC1100 ISA" rev 0x00
gpio0 at gscpcib0: 64 pins
"NS SC1100 SMI/ACPI" rev 0x00 at pci0 dev 18 function 1 not configured
pciide0 at pci0 dev 18 function 2 "NS SCx200 IDE" rev 0x01: DMA, channel 0
wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <SanDisk SDCFH-256>
wd0: 1-sector PIO, LBA, 245MB, 501760 sectors
wd0(pciide0:0:0): using PIO mode 4, DMA mode 2
"NS SCx200 AUDIO" rev 0x00 at pci0 dev 18 function 3 not configured
geodesc0 at pci0 dev 18 function 5 "NS SC1100 X-Bus" rev 0x00: iid 6 revision 3
wdstatus 0
isa0 at gscpcib0
isadma0 at isa0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
gscsio0 at isa0 port 0x2e/2: SC1100 SIO rev 1: ACB1 ACB2
iic0 at gscsio0
iic1 at gscsio0
lmtemp0 at iic1 addr 0x48: LM77
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
biomask f1e7 netmask ffe7 ttymask ffe7
pctr: no performance counters in CPU
nvram: invalid checksum
dkcsum: wd0 matched BIOS disk 80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
clock: unknown CMOS layout
WARNING: clock time much less than file system time
WARNING: using file system time
WARNING: CHECK AND RESET THE DATE!
