On Fri, 2016-09-09 at 11:37 +0200, Iago Toral wrote: > On Thu, 2016-09-08 at 11:36 +0200, Iago Toral wrote: > > > > On Wed, 2016-09-07 at 18:48 -0700, Francisco Jerez wrote: > > > > > > > > > This series reworks the representation of register region offsets > > > in > > > the i965 IR to be universally byte-based instead of the rather > > > awkward > > > split between reg_offset and subreg_offset we have in the FS > > > back- > > > end > > > right now, or the reg_offset field currently used in the VEC4 IR > > > which > > > doesn't allow better granularity than 32B. The most immediate > > > motivation is to enable sub-GRF offsets in the VEC4 back-end, > > > which > > > will be useful for various kinds of lowering and instruction > > > splitting > > > required for FP64 support on VEC4 platforms. > > Thanks a lot for taking care of this! > > > > > > > > > > > Patches 01-11 take care of scaling the regs_written and regs_read > > > instruction methods on both back-ends and the reg_offset register > > > field of VEC4 IR registers. The fs_reg::reg_offset and > > > ::subreg_offset fields are also unified into a single register > > > field. > > > Because this part of the series is rather bulky I've tried to > > > keep > > > the > > > changes as obvious and functionally equivalent as possible at the > > > cost > > > of introducing not particularly clever code in some cases that > > > could > > > be simplified with some knowledge of the context. Patches 31-46 > > > make > > > a second pass through the code touched in the first part of the > > > series > > > in order to get rid of an amount of cruft. > > I have reviewed this part and intend to continue reviewing the rest > > in > > the following days. Might be a good idea to have another set of > > eyes > > reviewing the series or at least skimming through it just in case. > > > > You might want to look at least at the second comment I made to > > patch > > 2 > > and the comment to patch 7, since these might be actual problems. > > All > > other comments are minor things or small clarifications and you can > > ignore them if you want. > > > > With the issues I point out in patches 2 and 7 addressed (or > > confirmation from your side that these are not real problems), > > patches > > 1-11 are: > > > > Reviewed-by: Iago Toral Quiroga <ito...@igalia.com> > > > > > > > > > > > Patches 12-30 address an amount of bugs that became obvious > > > during > > > the > > > conversion to byte units, some of them seem worrying enough that > > > it > > > might make sense to back-port them to stable releases. > I have just reviewed this part too and it looks good to me. > > You probably want to look at least at the comment to patch 25, since > I > think that might be a genuine mistake. The comment to patch 27 points > out a possible problem (but even if it is a problem it is not really > related this patch set). I find patch 28 a bit confusing since it > seems > to be doing something that is not quite right and then fixing it in > patch 29, I may be misunderstanding what is going on there, but > otherwise I think it would be best to squash both together. > > Other than these things, patches 12-31 are: > > Reviewed-by: Iago Toral Quiroga <ito...@igalia.com>
Patches 32-46 are: Reviewed-by: Iago Toral Quiroga <ito...@igalia.com> I hope to finish reviewing the series tomorrow. > > > > > > > > Patches 47-57 go through the VEC4 back-end and address a number > > > of > > > issues that would arise in existing optimization passes with > > > non-GRF-aligned regions, which will be useful for FP64 > > > support. It's > > > likely not complete and the handling of sub-GRF offsets doesn't > > > attempt to be nearly as clever as the FS back-end, but they > > > should > > > make a substantial improvement over the current situation. > > > > > > [PATCH 01/57] i965/fs: Replace fs_reg::reg_offset with > > > fs_reg::offset > > > expressed in bytes. > > > [PATCH 02/57] i965/vec4: Replace dst/src_reg::reg_offset with > > > dst/src_reg::offset expressed in bytes. > > > [PATCH 03/57] i965/ir: Remove backend_reg::reg_offset. > > > [PATCH 04/57] i965/fs: Replace fs_reg::subreg_offset with > > > fs_reg::offset expressed in bytes. > > > [PATCH 05/57] i965/fs: Add wrapper functions for > > > fs_inst::regs_read > > > and ::regs_written. > > > [PATCH 06/57] i965/vec4: Add wrapper functions for > > > vec4_instruction::regs_read and ::regs_written. > > > [PATCH 07/57] i965/fs: Replace fs_inst::regs_written with > > > ::size_written field in bytes. > > > [PATCH 08/57] i965/vec4: Replace vec4_instruction::regs_written > > > with > > > ::size_written field in bytes. > > > [PATCH 09/57] i965/ir: Drop backend_instruction::regs_written > > > field. > > > [PATCH 10/57] i965/fs: Replace fs_inst::regs_read with > > > ::size_read > > > using byte units. > > > [PATCH 11/57] i965/vec4: Replace vec4_instruction::regs_read with > > > ::size_read using byte units. > > > [PATCH 12/57] i965/fs: Return more accurate read size from > > > fs_inst::size_read for IMM and UNIFORM files. > > > [PATCH 13/57] i965/fs: Return more accurate read size for LINTERP > > > from fs_inst::size_read. > > > [PATCH 14/57] i965/fs: Handle arbitrary offsets in > > > brw_reg_from_fs_reg for MRF/VGRF registers. > > > [PATCH 15/57] i965/fs: Handle fixed HW GRF subnr in reg_offset(). > > > [PATCH 16/57] i965/fs: Take into account trailing padding in > > > regs_written() and regs_read(). > > > [PATCH 17/57] i965/fs: Take into account misalignment in > > > regs_written() and regs_read(). > > > [PATCH 18/57] i965/vec4: Take into account misalignment in > > > regs_written() and regs_read(). > > > [PATCH 19/57] i965/fs: Don't consider LOAD_PAYLOAD with sub-GRF > > > offset to behave like a raw copy. > > > [PATCH 20/57] i965/fs: Don't consider LOAD_PAYLOAD with stride > > > > 1 > > > source to behave like a raw copy. > > > [PATCH 21/57] i965/fs: Compare full register offsets in cmod > > > propagation pass. > > > [PATCH 22/57] i965/fs: Fix can_propagate_from() > > > source/destination > > > overlap check. > > > [PATCH 23/57] i965/fs: Fix LOAD_PAYLOAD handling in register > > > coalesce > > > is_nop_mov(). > > > [PATCH 24/57] i965/fs: Drop fs_inst::overwrites_reg() in favor of > > > regions_overlap(). > > > [PATCH 25/57] i965/fs: Stop using fs_reg::in_range() in favor of > > > regions_overlap(). > > > [PATCH 26/57] i965/vec4: Port regions_overlap() to the vec4 IR. > > > [PATCH 27/57] i965/vec4: Drop backend_reg::in_range() in favor of > > > regions_overlap(). > > > [PATCH 28/57] i965/fs: Take into account copy register offset > > > during > > > compute-to-mrf. > > > [PATCH 29/57] i965/fs: Fix bogus sub-MRF offset calculation in > > > compute-to-mrf. > > > [PATCH 30/57] i965/fs: Switch mask_relative_to() used in compute- > > > to- > > > mrf to byte units. > > > [PATCH 31/57] i965/fs: Fix signedness of the return value of > > > fs_inst::size_read(). > > > [PATCH 32/57] i965/fs: Simplify byte_offset(). > > > [PATCH 33/57] i965/fs: Simplify get_fpu_lowered_simd_width() by > > > using > > > inequalities instead of rounding. > > > [PATCH 34/57] i965/fs: Simplify and fix buggy stride/offset > > > calculations using subscript(). > > > [PATCH 35/57] i965/fs: Simplify result_live calculation in > > > dead_code_eliminate(). > > > [PATCH 36/57] i965/fs: Simplify a bunch of fs_inst::size_written > > > calculations by using component_size(). > > > [PATCH 37/57] i965/fs: Simplify copy propagation LOAD_PAYLOAD ACP > > > setup. > > > [PATCH 38/57] i965/fs: Change region_contained_in() to use byte > > > units. > > > [PATCH 39/57] i965/fs: Move region_contained_in to the IR header > > > and > > > fix for non-VGRF files. > > > [PATCH 40/57] i965/fs: Use region_contained_in() in compute-to- > > > mrf > > > coalescing pass. > > > [PATCH 41/57] i965/fs: Get rid of fs_inst::set_smear(). > > > [PATCH 42/57] i965/fs: Misc simplification. > > > [PATCH 43/57] i965/fs: Print fs_reg::offset field consistently > > > for > > > all register files. > > > [PATCH 44/57] i965/vec4: Print src/dst_reg::offset field > > > consistently > > > for all register files. > > > [PATCH 45/57] i965/ir: Don't print ARF subnr values twice. > > > [PATCH 46/57] i965/ir: Update several stale comments. > > > [PATCH 47/57] i965/vec4: Simplify src/dst_reg to brw_reg > > > conversion > > > by using byte_offset(). > > > [PATCH 48/57] i965/vec4: Change opt_vector_float to keep track of > > > the > > > last offset seen in bytes. > > > [PATCH 49/57] i965/vec4: Check that the write offsets match when > > > setting dependency controls. > > > [PATCH 50/57] i965/vec4: Compare full register offsets in > > > opt_register_coalesce nop move check. > > > [PATCH 51/57] i965/vec4: Don't coalesce registers with > > > overlapping > > > writes not matching the MOV source. > > > [PATCH 52/57] i965/vec4: Assign correct destination offset to > > > rewritten instruction in register coalesce. > > > [PATCH 53/57] i965/vec4: Compare full register offsets in cmod > > > propagation. > > > [PATCH 54/57] i965/vec4: Fix copy propagation for non-register- > > > aligned regions. > > > [PATCH 55/57] i965/vec4: Don't spill non-GRF-aligned register > > > regions. > > > [PATCH 56/57] i965/vec4: Assert that ATTR regions are register- > > > aligned. > > > [PATCH 57/57] i965/vec4: Assert that pull constant load offsets > > > are > > > 16B-aligned. _______________________________________________ mesa-dev mailing list mesa-dev@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/mesa-dev
