We use the 2824 for wristbands and the 2844 for some PHA labeling.  If
the data is formatted correctly I can't say that I've seen them just
stop printing part of the data.  I've seen data not show up when it is
formatted outside the edge of the label/wristband.  During setup I had
an issue with incorrect use of ZPL spacing codes that would eventually
get the printer mis-configured so that it wouldn't print properly.  

How are you sending data to the printer?  I'd start by looking at the
input to the printer to see if it is still specifying a barcode.  Did
the NPR/Optio/whatever that is feeding the printer change?

 

________________________________

From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf
Of Pearey, Tom
Sent: Monday, January 08, 2007 4:51 PM
To: [email protected]
Subject: [MEDITECH-L] Zebra printer

 

Is anyone using a Zebra  LP2844 to print bar codes.  We use the Zebra to
print patient's wristbands and at one time it was printing patient info
along with a barcode.  The barcode suddenly stopped printing.  Any info
would be greatly appreciated.  

 

Tom Pearey-MIS Mgr.

Pacific Alliance Med. Ctr.

Ph# 213-437-4268

Fax 213-617-9203

[EMAIL PROTECTED]

 

=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
To subscribe or unsubscribe to the meditech-l, visit MTUsers.COM.

To check the status of the meditech-l, visit MTUsers.NET.

For help, email [EMAIL PROTECTED]
______________________________________
meditech-l mailing list
[email protected]
http://mtusers.com/mailman/listinfo/meditech-l

Reply via email to