On 8-Nov-08, at 10:45 PM, Bryan Blackburn wrote:
On Sat, Nov 08, 2008 at 08:37:45PM -0500, Charles Darwin said:
On 8-Nov-08, at 8:33 PM, Daniel J. Luke wrote:
On Nov 8, 2008, at 7:57 PM, Charles Darwin wrote:
On 8-Nov-08, at 3:50 PM, Ryan Schmidt wrote:
On Nov 8, 2008, at 09:11, Charles Darwin wrote:
Does anyone know where the zenmap.conf is? I need to enable
zenmap. Shouldn't there be a variant for it?
What port are we talking about?
nmap
The nmap port does not install the zenmap gui. (Patches welcome for
enhancements).
I read about it here:
<http://nmap.org/book/inst-macosx.html>
"To enable Zenmap to find it, set the nmap_command_path variable in
zenmap.conf to /sw/bin/nmap or/opt/local/bin/nmap as described in the
section called “The nmap Executable”."
That only applies if you install zenmap via some other method, since
the
nmap port doesn't currently install it. However, see
<http://trac.macports.org/ticket/17148>
Once that's done you shouldn't have to mess with zenmap.conf as long
as
/opt/local/bin is in your PATH.
Bryan
$ port installed nmap
The following ports are currently installed:
nmap @4.76_0+zenmap (active)
That was quick. Thanks,
Charles
_______________________________________________
macports-users mailing list
[email protected]
http://lists.macosforge.org/mailman/listinfo.cgi/macports-users
