Jake, REX2 is not supported at all anymore. Really should just take it out and replace it!
And certainly the new firmware does not work on it. To recover that I think you might need to completely reload everything. Btw nice to hear from you again. Steve On Saturday, November 27, 2021, Jake Bickhard <[email protected]> wrote: > Last night I was poking around my M100 after replacing the internal > battery and refamiliarizing myself with NADSBox and re-figuring out REX2, > when I saw that I was on software 4.5 instead of 4.9. Downloaded the update > to my SD card, followed the instructions to rebuild, and it seemed to stick > on "Loading 0: RXF149.BR". I moved the machine from my laptop to my desk > and it abruptly rebooted when I set it down. Subsequent CALL63012 simply > hang the machine and hard-reset it. Subsequent attempts at re-installing > 4.9 hang again at "Loading 0: RXF149.BR" for as long as 7 hours. I > attempted to reinstall software 4.5 which seemed to complete successfully > but running rexmgr informed me that there was a directory mismatch and > whether I chose to keep or replace it the next step would hang > indefinintely. > > Unfortunately I also erased my SD card at one point during troubleshooting > without realizing that, upon further reading, the 4.9 rebuild would have > backed up the REXs state. Not sure if that would have been useful in this > situation but I definitely didn't notice it when I cleared the SD card of > other files in case they were interfering. > > Not too upset if this isn't fixable; the REX# looks fantastic and I'll > happily order one, just hate to waste hardware due to my own silly mistakes. > > Any advice appreciated. I'm going to give the 4.5 install another shot > after re-seating the REX2 itself; though it worked fine before I went and > tried to update it. > > -Jake >
