Correct, VT100 emulation. On Tue, Nov 16, 2021 at 2:15 PM Stephen Adolph <[email protected]> wrote:
> there will be escape characters flowing over serial in this case, so you > need to ensure that does not mess with things. > If I understand what is happening > > M100 ----> PC (video terminal character flow) > M100 <---- PC (input keyboard strokes) > > When you say the terminal works reliably using F3, you are using the PC as > a display for CP/M, right? And in this case, you selected VT100 emulation? > > > > > On Tue, Nov 16, 2021 at 5:05 PM Tom Hoppe <[email protected]> wrote: > >> I left minicom set to 19200 8N1 and it worked (until it didn't). The Sc L >> vs Sc S is a good point! I will try changing this tonight and see if >> it helps. My ultimate goal is to ssh into my home PC from work so I can >> play with CP/M during lunch :). >> >> Tom >> >> >> On Tue, Nov 16, 2021 at 11:21 AM Jim Anderson <[email protected]> >> wrote: >> >>> First thought that comes to mind: it may be stopping because of the >>> feature which pauses the screen output after 8 lines of consecutive output >>> – try Label-F1-Label to toggle ‘Sc L’ to ‘Sc S’ to disable this before >>> redirecting the console? >>> >>> >>> >>> I’m glad to see this post because I honestly had been thinking a while >>> back that “I wish there was a way to use a ps/2 keyboard with my MVT100 >>> board as a full-blown terminal” but didn’t try anything because I’m not >>> familiar enough with CP/M to know how to redirect the console like that. >>> What baud rate does it end up using when you do this? >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> jim >>> >>> >>> >>> *From:* M100 <[email protected]> *On Behalf Of *Tom >>> Hoppe >>> *Sent:* Tuesday, November 16, 2021 10:50 >>> *To:* [email protected] >>> *Subject:* [M100] Re-directing CP/M console to serial port in REXCPM >>> >>> >>> >>> *CAUTION External Sender:* Do not click links or open attachments >>> unless you recognize the sender and know the content is safe. >>> >>> >>> >>> I am trying to re-direct the REXCPM console to the M100 serial port but >>> only having limited success. I am using 'stat con:=uc1:' to do the >>> re-direct. It seems to work for a minute, then stops. I am using minicom in >>> Linux and it works reliably using the REXCPM 'F3 toggle' feature to >>> re-direct only the screen output (19200 8N1). Has anyone else tried doing >>> this successfully? >>> >>> >>> >>> Tom Hoppe >>> >>> >>> >>>
