Peter Kümmel wrote:
Abdelrazak Younes wrote:
Juergen Spitzmueller wrote:
Peter Kümmel wrote:
It seems this could be done by a lyx newbie like me.
You're clearly not a newbie, but it could even be done by a newbie.
Adding a RC_TABLE_LINES to LyXRC and then using
lyxrc.read(RC_TABLE_LINES) in the ctor?
Also an item in the "look and feel" ui interface?
Or is this not the way it should be done?
I wouldn't use a lyxrc. I would add a combo to the tabular create
dialog, where you can select, and save the selection (like the
crossref dialog does, for instance).
Ah wait, the qt4 frontend doesn't have a tabular create dialog anymore
... That's bad, I'd like it to be selectable for every new tabular.
No, a default behavior doesn't need any choice. That's very bad UI wise.
But you could configure in the Preference dialog _your_ default behavior
to your will of course. If, in a special case you want to modify _your_
default settings, just for this particular table, launch the full blown
table dialog (which is still available contrarily to what you say).
Abdel.
I also think a overall default behavior must not be changed in a dialog
for one special table. But the Table dialog really misses on option to
remove/add ALL lines, which then also applies to added columns and rows.
Abdel is this the "default settings, just for this particular table"
which which you are talking about?
But what is the right place to add the overall default settings in the
Preferences dialog?
Dunno, maybe a button "Save Default Settings" in the "Tabular Create"
dialog would be better.
Abdel.
