On 09-Jul-2001 Saalfeld, Christoph wrote:
> I close my figure floats to reduce the length of my document while working
> on it. The only problem is to minimize/close a figure float that contains a
> figure, that is higher than my screen (the LyX window is already
> maximized). In that case LyX jumps to the end of that figure float and does
> not recognize the click on the "Close/Open" edge of the figure float.
This is most probably a bug. IMO there is a menu entry or a command to
open/close a float (but I'm not sure about it). Anyway all this code is
new in 1.2.0 and the old code was already removed from the source. So
this should be fixed in the upcoming 1.2.0 version ;)
Jürgen
--
-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._
Dr. Jürgen Vigna E-Mail: [EMAIL PROTECTED]
Italienallee 13/N Tel/Fax: +39-0471-450260 / +39-0471-450253
I-39100 Bozen Web: http://www.sad.it/~jug
-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._-._
When this load is DONE I think I'll wash it AGAIN ...
