Am Sonntag, dem 28.07.2024 um 14:43 -0400 schrieb Richard Kimberly Heck: > I played around with it a bit, and it seems to work well, for the > most part. In particular, it does fine with duplicate section > headings, etc.
Very good. > But I did run into one problem. Create a new document. Make it look > like this: Strange, I cannot reproduce. However: > [reference-to-paragraph] is disabled at this location > frontends/qt/GuiApplication.cpp (5f0): dispatch msg is `Command > disabled' This might give a hint. I messed up the definition of the lfun, maybe this was the reason? Please check after 2fdeee4bf78d8. Otherwise, the function is only disabled if: * par ID is < 1 (which shouldn't happen AFAIU) * the TocItem does not have a valid DocIterator The latter does only apply to the Outliner. So you could also test if the lfun itself works by using reference-to-paragraph 1 > frontends/qt/GuiApplication.cpp (5f0): dispatch msg is `' > > If I save the document, then it works. It also does not seem to > happen > if I load a document from disk---hence the need to create a new > document. It does work to insert a reference > > I saw the note on the bug report about extending this to the cross- > ref dialog. I'd be happy to do that part, once this is otherwise > stable. Thank you, this would be great. We'd might need to move some code from TocWidget to TocModel (or even TocBackend) to give access to that dialog. The move is probably a good one anyway. In any case, I'll be happy to help out on this. -- Jürgen -- lyx-devel mailing list lyx-devel@lists.lyx.org http://lists.lyx.org/mailman/listinfo/lyx-devel
