On 02/02/2018 12:23 PM, Jean-Pierre Chrétien wrote: > Le 02/02/2018 à 02:59, Richard Heck a écrit : >> On 02/01/2018 01:59 PM, Scott Kostyshak wrote: >>> On Tue, Jan 30, 2018 at 02:37:28AM +0000, Scott Kostyshak wrote: >>> >>>>> <cite> >>>>> +checking list of textclasses... >>>>> Layout file /usr/local/share/lyx-2.3.0rc2/layouts/svglobal3.layout >>>>> has no >>>>> \DeclareXXClass line. >>>>> Layout file /usr/local/share/lyx-2.3.0rc2/layouts/ectaart.layout >>>>> has no >>>>> \DeclareXXClass line. >>>>> [...] >>>>> Layout file /usr/local/share/lyx-2.3.0rc2/layouts/bxjsbook.layout >>>>> has no >>>>> \DeclareXXClass line. >>>>> Layout file /usr/local/share/lyx-2.3.0rc2/layouts/letter.layout >>>>> has no >>>>> \DeclareXXClass line. >>>>> </cite> >>>> I see these also. We should figure this out, but it's good to know it >>>> doesn't cause any problem. >> >> It very much would cause a problem in certain cases, namely, if you use >> --without-latex-config, or if there's some later problem with >> chkconfig.ltx. Then textclass.lst is empty. >> >>> git bisect suggests 731c9fb4 caused the change. >> >> I put in some debugging code, and the regex simply isn't matching the >> lines of the file the way it is supposed to. Ever. >> >> The attached patch fixes it for me. It looks like one of those weird >> double-escaping problems. I'm not sure why the switch to binary strings >> would cause this, but apparently it does. > > I patched lyx-2.3.0rc2 with it, and same behavior. > > In the preceding mail, I stated that I did not see anymore the 'no > \DeclareXXClass line' messages when I launched lyx-2.3.0.rc2 again. > In fact, to trigger again the messages, I have to remove ~/.lyx-2.3.0rc2.
You can just remove textclass.lst. Alternatively, run configure.py manually with --without-latex-config and then inspect textclass.lst. If it's empty, that's a problem. If it's not, we're good. > If I do this and patch (no recompilation required, right?), I still > get the messages. You don't need to recompile, but you would need to re-run "make install". Otherwise, the old configure.py is still being used from /usr/local/share/lyx/ or whatever. Richard
