Hi all:
I use macvlan as the network configuration for my LXC VMs.
Here is my configuration for LXC VMs:
lxc.network.type = macvlan
lxc.network.macvlan.mode = vepa
lxc.network.flags = up
lxc.network.link = tap0
and I config 4 virtual eth in this VMs, each has the tap0 as its
network link.
I use a tap device as the link for the macvlan, and I run a process
to read and write this tap device.
when I write a ARP quest to the tap device, the macvlan didn't
broadcast the packet to the network interface in the VM.
I put some debug code in the macvlan.c and runs this test. and I find
the skb did not even enter the macvlan_handle_frame function.
Could someone tell me is there any thing wrong in my config?
thx~~
--
hepeng
ICT
------------------------------------------------------------------------------
This SF Dev2Dev email is sponsored by:
WikiLeaks The End of the Free Internet
http://p.sf.net/sfu/therealnews-com
_______________________________________________
Lxc-devel mailing list
Lxc-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/lxc-devel
