Hi. Atul kumar wrote: > I have configured the LVS/Ldirector in HA setup. 2 servers for Load Balancer > (LB), 2 for web servers. The heartbeat failover is working fine and the LB > too is working fine. But I want to run the LB in Active / Active mode. But > the restriction for me is with the IP address. I have only one public IP > which I want to use for this Active / Active LB setup.
AFAIK there are 3 ways of doing active-active with LVS: 1. Using multiple IPs and multiple A DNS records You have multiple public IPs and let DNS round robin (or another external process - perhaps at the client) balance the initial connections between the LVSs which in turn balance the connections between any number of real servers. This is definitely the most simple approach if you just have a few VIPs and need to have 2 active-active LBs. 2. Saru Saru (IIRC) uses a shared MAC so that all load balancers get all the traffic and then agrees among the load balancers which part of the traffic each load balancer should actually balance. See, http://www.ultramonkey.org/papers/active_active/ for more information. This code is probably somewhat old and I'm not sure if it's maintained. Also as all LBs get all the traffic, the amount of traffic you can handle is limited by the speed of the slowest network interface on your LBs. 3. Multipath routes from router to LVSs If you can configure the routers or set up a routing protocol (like OSPF) between the routers and the load balancers then you can organize that the routers have a multipath route to the VIP through all of the load balancers. Then the routers would handle the first tier of balancing the traffic between load balancers, which in turn would balance the traffic between all the real servers. This requires support from the routers on your network, which you may or may not have. You can check the list archives and possibly the howto (for saru at least) - there have been some discussions regarding this. Siim _______________________________________________ Please read the documentation before posting - it's available at: http://www.linuxvirtualserver.org/ LinuxVirtualServer.org mailing list - lvs-users@LinuxVirtualServer.org Send requests to lvs-users-requ...@linuxvirtualserver.org or go to http://lists.graemef.net/mailman/listinfo/lvs-users
