I am doing some testing on this set up and I am unable to talk to the
Dlink 4G router, IT is connected by a short cat5 cable to the eth0. This
port is setup with an address of 192.168.1.6 and is the default route
for the machine. Eth1 is connected to my switch connected to my other
machine, this port has an address of 192.168.1.1 (ie my gateway machine)
Both interfaces are up. THe IP address of the Dlink 4G router is
192.168.0.1, when I point a browser at this address (either Firefox of
links2) there is no response, ifconfig shows some data is excahanged
(around 200 bytes tranmsited and 50 received, so the connection appears
to work.
What am I doing wrong, everyone makes out it is simple to communicate
with these things. What config is required to talk to one of these self
contained routers connected to an ethernet port.
Lindsay
_______________________________________________
luv-main mailing list
[email protected]
https://lists.luv.asn.au/cgi-bin/mailman/listinfo/luv-main
