Hi all,
I’ve seen many questions/issues came by and I decided to post the issue that I
encountered.
Recently I tried updating the mgsnode IP address on a lustre node and although
the command executed successfully, the old IP value remained.
Old value: 10.10.10.2 (points to a server that is not a mgsnode)
New value:
10.10.10.201@o2ib,10.10.10.202@o2ib,10.10.10.203@o2ib,10.10.10.204@o2ib
Please find the command and output below:
[root@xxx ~]# tunefs.lustre --erase-param mgsnode --writeconf
--mgsnode=10.10.10.201@o2ib,10.10.10.202@o2ib,10.10.10.203@o2ib,10.10.10.204@o2ib
zfs_R10_nvme0-4/dne_mdt1
checking for existing Lustre data: found
Read previous values:
Target: neohpfs-MDT0001
Index: 1
Lustre FS: neohpfs
Mount type: zfs
Flags: 0x1
(MDT )
Persistent mount opts:
Parameters: mgsnode=10.10.10.2@o2ib
Permanent disk data:
Target: neohpfs=MDT0001
Index: 1
Lustre FS: neohpfs
Mount type: zfs
Flags: 0x141
(MDT update writeconf )
Persistent mount opts:
Parameters:
mgsnode=:10.10.10.201@o2ib,10.10.10.202@o2ib,10.10.10.203@o2ib,10.10.10.204@o2ib
[root@xxx ~]#
I did restart the lustre service thinking this would perhaps load the new
value/config and although the service came up successfully, it still had not
loaded the new value.
Appreciate any help, suggestions you can provide as to why the new value was
not saved/loaded. In case I made a mistake, or I followed the incorrect
step(s)/process than please, feel free to point that out.
Best Regards,
Ricardo
_______________________________________________
lustre-discuss mailing list
[email protected]
http://lists.lustre.org/listinfo.cgi/lustre-discuss-lustre.org
