Hi, I am creating a tunnel with another party that is using a Cisco ASA5520. Phase 1 is negotiating just fine.
Phase 2 will not come up. I am using my LAN Subnet on my side and made sure they have the same settings. They are using a public routable IP on their side for the remote network. ex. Their VPN endpoint of the ASA is 111.222.333.25 and they are using 111.222.333.140/32 for the remote network. I have that remote network set on my side in Phase 2 - 111.222.333.140/32 When I go to pfSense Status and click on the little start icon next to the phase 2 entry it is yellow with an x, once pushed the tunnel does not come up green, but stays yellow with and x. Am I setting the remote network properly on my side of phase 2? I have seen some cryptic error messages in the log viewer in pfsense. Is there a key to decode these message codes? 3 examples 1. error message: 'r I'. 2. error message: 'B'. 3. error message: 'n'. Best Regards, -- Mark Street, D.C., RHCE Chief Technology Officer Alliance Medical Center (707) 433-5494
_______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
