The H_SET_MODE hcall returns H_P2 if a function is not implemented
and all callers should handle this case.
The call to enable relocation on exceptions currently prints an error
message if the feature is not implemented. While H_SET_MODE was
first introduced on POWER8 (which has relocation on exceptions), it
has been now added on some POWER7 configurations (which does not).
Check for H_P2 and print an informational message instead.
Signed-off-by: Anton Blanchard <an...@samba.org>
---
arch/powerpc/platforms/pseries/setup.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/arch/powerpc/platforms/pseries/setup.c
b/arch/powerpc/platforms/pseries/setup.c
index 125c589..fcc9227 100644
--- a/arch/powerpc/platforms/pseries/setup.c
+++ b/arch/powerpc/platforms/pseries/setup.c
@@ -499,7 +499,11 @@ static void __init pSeries_setup_arch(void)
if (firmware_has_feature(FW_FEATURE_SET_MODE)) {
long rc;
- if ((rc = pSeries_enable_reloc_on_exc()) != H_SUCCESS) {
+
+ rc = pSeries_enable_reloc_on_exc();
+ if (rc == H_P2) {
+ pr_info("Relocation on exceptions not supported\n");
+ } else if (rc != H_SUCCESS) {
pr_warn("Unable to enable relocation on exceptions: "
"%ld\n", rc);
}
--
1.9.1
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
