Register bootmem pages at boot time on powerpc.
Previous commit 46723bfa540... introduced a new config option,
HAVE_BOOTMEM_INFO_NODE, to enable registering of bootmem pages. As a result
the bootmem pages for powerpc are not registered since we do not define this.
This causes a BUG_ON in put_page_bootmem() when trying to hotplug remove
memory on powerpc.
This patch resolves this by doing three things;
- define HAVE_BOOTMEM_INFO_NODE for powerpc
- Add a routine to register bootmem via register_page_bootmem_info_node()
in mem_init().
- Stub out the register_page_bootmem_memmap() routine needed for building
with SPARSE_VMEMMAP enabled.
Signed-off-by: Nathan Fontenot <nf...@linux.vnet.ibm.com>
---
arch/powerpc/mm/init_64.c | 6 ++++++
arch/powerpc/mm/mem.c | 9 +++++++++
mm/Kconfig | 2 +-
3 files changed, 16 insertions(+), 1 deletion(-)
Index: powerpc/arch/powerpc/mm/init_64.c
===================================================================
--- powerpc.orig/arch/powerpc/mm/init_64.c
+++ powerpc/arch/powerpc/mm/init_64.c
@@ -300,5 +300,11 @@ void vmemmap_free(unsigned long start, u
{
}
+void register_page_bootmem_memmap(unsigned long section_nr,
+ struct page *start_page, unsigned long size)
+{
+ WARN_ONCE(1, KERN_INFO
+ "Sparse Vmemmap not fully supported for bootmem info
nodes\n");
+}
#endif /* CONFIG_SPARSEMEM_VMEMMAP */
Index: powerpc/arch/powerpc/mm/mem.c
===================================================================
--- powerpc.orig/arch/powerpc/mm/mem.c
+++ powerpc/arch/powerpc/mm/mem.c
@@ -297,12 +297,21 @@ void __init paging_init(void)
}
#endif /* ! CONFIG_NEED_MULTIPLE_NODES */
+static void __init register_page_bootmem_info(void)
+{
+ int i;
+
+ for_each_online_node(i)
+ register_page_bootmem_info_node(NODE_DATA(i));
+}
+
void __init mem_init(void)
{
#ifdef CONFIG_SWIOTLB
swiotlb_init(0);
#endif
+ register_page_bootmem_info();
high_memory = (void *) __va(max_low_pfn * PAGE_SIZE);
set_max_mapnr(max_pfn);
free_all_bootmem();
Index: powerpc/mm/Kconfig
===================================================================
--- powerpc.orig/mm/Kconfig
+++ powerpc/mm/Kconfig
@@ -183,7 +183,7 @@ config MEMORY_HOTPLUG_SPARSE
config MEMORY_HOTREMOVE
bool "Allow for memory hot remove"
select MEMORY_ISOLATION
- select HAVE_BOOTMEM_INFO_NODE if X86_64
+ select HAVE_BOOTMEM_INFO_NODE if (X86_64 || PPC64)
depends on MEMORY_HOTPLUG && ARCH_ENABLE_MEMORY_HOTREMOVE
depends on MIGRATION
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
